As the acid heats the water during the mixing the hydrometer reading should not be taken until the heat caused by the first addition of acid has been reduced to that of the room. Taking a reading with a hot solution will give inaccurate results, unless, of course, the reading is reduced to normal by the method described in a previous chapter. When the reading has been taken and found to be correct and the solution has been reduced to the temperature of the room, the electrolyte may be poured into the cell through the filler openings in the top of the cell. Pour into each cell sufficient fluid to cover the plates but avoid filling the cell to the top, or flooding it. At the end of the charging time given by the maker, withdraw a sample of the electrolyte by means of a syringe and test the specific gravity. This should not be over 1,290 for a fully charged cell, and if the solution exceeds this amount, pure water should be added until the proper point is reached. Always correct the specific gravity in this way every time the battery is charged as evaporation and internal chemical changes cause the density to change from time to time. The voltage of a good storage battery will be about 2.1 volts when fully charged. Overcharging is wasteful and finally destroys the cell, the effects being similar to those caused by excessive discharges, that is, buckled plates and loosened active material. Overcharging a sulphated battery may cure the trouble, a little overcharging at intervals being better than a long continued overcharge. An increase in the specific gravity of the electrolyte of from 30 to 50 degrees, with a corresponding rise of voltage, shows that the cell is fully charged. After the charging is completed remove all of the solution spilled on the battery, preferably by washing, and wipe bone dry. If the solution is higher in the air, remove the excess with the syringe. (87) Make and Break System (Low Tension). When a circuit carrying a current is opened or broken at any place in its length, an electric spark will occur at the point at which the wires or contacts are separated. This is due to what might be termed the “momentum” of the current which causes it to persist in its course even to the extent of jumping over a short distance of the highly resistant air in the gap. The size and heat of the spark may be increased by placing a coil of copper wire in series with the circuit that has an iron core in the center of the turns. This coil increases the tendency of the current to jump the gap, or in other words increases the momentum of the circuit.