After you have marked out the dimensions for the three-cornered piece that is to throw the shadow, you can prepare the dial itself, with the lines that mark the place of the shadow for every hour of the day. This you can do in the manner shown in Fig. 3. Just as in the case of the three-cornered piece, you can draw the dial with a pencil directly on a smooth piece of white board, about three-quarters of an inch thick, or you can mark it out on a paper pattern and transfer it afterward to the board. Perhaps it will be as well to begin by drawing on paper, as any mistakes can then be corrected before you commence to mark your wood. [Illustration: Fig. 3.] In the first place you must draw a couple of lines MN and M′N′, eight inches long, and just far enough apart to fit the edge of your three-cornered shadow-piece. You will remember I told you to make that one-half inch thick, so your two lines will also be one-half inch apart. Now draw the two lines NO and N′O′ square with MN and M′N′, and make the distances NO and N′O′ just five inches each. The lines OK, O′K′, and the other lines forming the outer border of the dial, are then drawn just as shown, OK and O′K′ being just eight inches long, the same as MN and M′N′. The lower lines in the figure, which are not very important, are to complete the squares. You must mark the lines NO and N′O′ with the figures VI, these being the lines reached by the shadow at six o'clock in the morning and evening. The points where the VII, VIII, and other hour-lines cut the lines OK, O′K′, MK, and M′K′ can be found from the table on page 78. In using the table you will notice that the line IX falls sometimes on one side of the corner K, and sometimes on the other. Thus for Albany the line passes seven and seven-sixteenth inches from O, while for Charleston it passes four and three-eighth inches from M. For Baltimore it passes exactly through the corner K. TABLE SHOWING HOW TO MARK THE HOUR-LINES.