1. ~Sulphurous acid.~--When sulphur is burned, sulphur dioxide gas is formed. In the presence of moisture, or when dissolved in water, this gas forms sulphurous acid, which is one of the most commonly used bleaching chemicals for all sorts of materials, and is very effective for decolorizing furs. The procedure usually followed is to hang up the moistened skins on wooden rods in a more or less cubical chamber made of stone or brick, and lined with wood or lead. No other metals may be used, because they are quickly corroded by the sulphurous acid. The requisite quantity of sulphur is placed in a pot in the bleaching chamber, and then ignited, after which the doors are shut tight. The fumes of the burning sulphur in contact with the moist hair readily exert their bleaching action on the furs, and the operation is allowed to proceed for six or eight hours, or overnight. Then by means of fans or other devices, the air filled with sulphur dioxide gas is withdrawn from the chamber, and replaced by fresh air. The door is opened, the skins removed, exposed to the air for a time, then rinsed, and finally dried and finished. Sometimes one operation is not enough to sufficiently bleach the hair, so the process is repeated. Sulphur dioxide gas can now be obtained compressed in cylinders, which are more convenient to handle than burning sulphur. The flow of gas which is introduced into the bleaching chamber by means of a nozzle attached to the cylinder, can be regulated, and the bleaching thus retarded or accelerated. 2. ~Sodium bisulphite and sodium sulphite.~--These salts of sulphurous acid are effective in their bleaching action only when in solution in the presence of acids. The acids liberate sulphurous acid from the salts, so this method is virtually the same as 1. Instead of using the salts of sulphurous acid, sulphur dioxide may be dissolved in water, and the solution used for bleaching by immersing the furs in it. This procedure, while consuming somewhat less time than the chamber process, is more likely to affect the leather, which would have to be retanned. The principle is the same as that involved in method 1. 3. ~Hydrosulphites and derivatives.~--The bleaching agent can be prepared by adding zinc dust to commercial bisulphite of soda dissolved in about four times its weight of water until no more reaction is evident. Milk of lime is then added to precipitate the zinc, and the clear supernatant liquid of 1.5°–5° Tw. is used for bleaching. The skins are immersed for 12–24 hours, taken out, washed and finished. Instead of preparing the hydrosulphite, the commercial products may be used with greater convenience, a solution containing 1–4% of the hydrosulphite powder being used, and the skins treated in this until satisfactorily bleached.