is made an invariable rule to move the strip for the next exposure as soon as the slide is closed. Otherwise double exposures are liable to occur. When a strip is completely exposed it is removed in the dark, and a new one put in place. The former is carefully labeled and dated on the back, and put away in a light-tight box in a cool place. [Illustration: Fig. 12. Dawson-Lander sun recorder.] =80. The Dawson-Lander sun recorder.= “The instrument consists of a small outer cylinder of copper which revolves with the sun, and through the side of which is cut a narrow slit to allow the sunshine to impinge on a strip of sensitive paper, wound round a drum which fits closely inside the outer cylinder, but is held by a pin so that it can not rotate. By means of a screw fixed to the lid of the outer cylinder, the drum holding the sensitive paper is made to travel endwise down the outer tube, one-eighth of an inch daily, so that a fresh portion of the sensitive surface is brought into position to receive the record.” The instrument is driven by an eight-day clock placed in the base below the drum. The slit is covered by means of a flattened funnel-shaped hood, and the photographic strip is protected from rain by a perfectly transparent sheet of celluloid. The detailed structure of the instrument is shown in figure 12. This instrument may be obtained from Lander and Smith, Canterbury, England, for $35. In setting up the sunshine recorder, the axis should be placed in such a position that the angle which it makes with the base is the same as the altitude of the place where the observations are made. This is readily done by loosening the bolts at either side. The drum is removed, the celluloid sheet unwound by means of the key which holds it in place, the sensitive strip put in position, and the sheet again wound up. Strips of a special sensitive paper upon which the hours are indicated are furnished by the makers of the instrument, but it has been found preferable to use solio strips in order to facilitate comparison with the standards. The drum is placed on the axis, and is screwed up until it just escapes the collar at the top of the spiral. The clock is wound and started, and the outer cylinder put on so that the proper hour mark coincides with the index on the front of the base.