The steam passes from the stop-valve, A, Fig. 4, through the steam pipe, D, to the high pressure cylinder, C, and having done its work, goes into the receiver, R, where it is heated. From the receiver it is led into the low-pressure cylinder, C1, and thence into the condenser. Provision is made for working both engines independently with direct steam when desired, suitable gear being provided for supplying steam of the proper pressure to the condensing engine, so that each engine shall perform exactly the same amount of work. The starting gear consists of a hand-wheel, H, which controls the stop valve, A, and of another h, which opens the valves for the jackets of the cylinders and receiver. The hand-wheel, h1 and h2, govern the valves, which turn the steam direct into the two cylinders. There are also lever, g, which opens the principal injection cock, H1, and the auxiliary injection cock, H2, the function of which is to assist in forming a speedy vacuum, when the engine has been standing for some time. [Illustration: BORSIG'S IMPROVED COPOUND BEAM ENGINE. FIG. 2] The drum is 6.08 m. diameter, the breadth being 2.04 m., with a total weight of 33,000 kilos. The beams are of cast iron with balance weights cast on. The connecting rods and cross beams are of wrought iron, and the cranks, crank shaft, piston rods, valve rods, etc., of steel. The bed-plate for the main shaft bearings are cast in one piece with the standards for the beam, which are connected firmly together by the center bearing, M M1, which is cast in one piece, and also by the diagonal bracing piece, N N1. The construction of the cylinder and valve chests is shown in Fig. 1. The working cylinder is in the form of a liner to the cylinder, thus forming the steam jacket, with a view to future renewal. This lining has a flange at the lower part for bolting it down, being made steam-tight by the intervention of a copper packing ring. There is a similar ring at the upper part which is pressed down by the cylinder cover. The latter is cast hollow and strengthened by ribs. The pistons are provided with cast iron double self-expanding packing rings. For preventing accidents by condensed water, spring safety valves, ss and s1 s1, are connected to the valve chests. The valve gear, which is arranged in the same manner for both cylinders, is actuated by shafts, w and w1, rotated by toothed wheels as shown. Motion is communicated from the way-shafts, w and w1, by the eccentrics, and the eccentric rods, e1 e2 e3 e4, and the levers and rods belonging thereto, to the short steam valve rocking shafts levers, f1 f2 f3 f4, and the exhaust valve rocking shafts, k1 k2 k3 k4, the bearings of which are carried on brackets above the valve chests, which, being furnished with tappet levers, raise and lower the valves. [Illustration: BORSIG'S IMPROVED COPOUND BEAM ENGINE. FIG. 3]