The movable bottom, K (Figs. 5 and 6), which closes the base of the filter during the pressing, becomes detached and drops vertically (Figs. 3 and 4), when the filter is disengaged from the press, and the oil cake is to be dropped out. To render the maneuver of this part easy, the bottom is provided with a projecting piece, N, united by a bolt with the band, I, and furnished with an articulated hand-lever, N', that terminates in an appendage, q. The upper part of the hinge is provided with a tail piece, q', under which the appendage q, places itself when the bottom, K, is brought to its horizontal position. Consequently, when the operator desires to let the bottom drop in the position shown by the dotted line (Fig. 5), after the filter has been loosened, he moves the lever, N, to the position shown by the dotted line (Fig. 6). The appendage, q, then disengages itself from the tail piece, q', and the bottom is thus enabled to assume a vertical position. As the bottom at the time of charging would not be sufficiently supported if there merely existed the lever and catch, it is further provided at its opposite extremity with an appendage, r, which slides over a catch, r'. This latter is attached to the disk, m, at the lower extremity of the pin, j (Fig. 7), and takes exactly the proper position when the band is closed at the moment of charging, but leaves it, on the contrary, when the band is loosened to allow the oil cake to drop out. As the lateral flow takes place through the interstices of the brass lining, there is need of but one cushion on the bottom and another at the top to hold the material to be pressed. The first is a simple hair-cloth disk for preventing the seed from passing through the perforations in the bottom plate; and the second, O, of which Figs. 12 and 13 represent a segment, is formed of three thicknesses of the same material united at the edges by two flat iron circles, s, riveted together. These circles, which are made to fit the inside diameter of the shells very accurately, prevent any leakage of the oil around the presser, G, and keep the hairs from getting caught between this piece and the plates, b. _Charging of the Filter_. (Figs. 14 and 15.)--The apparatus for charging the filter is of the same capacity as the latter, and is made of galvanized iron. It is placed on a slide at the aperture of the steam kettle so as to receive the warm seed as it is thrown out by the stirrer. When full, it is taken up by its handles, rested on the rim of the filter, and its contents emptied therein.