Where the water can be supplied by gravitation, and the tanks can be placed at a sufficient elevation to command the service cistern, no pumps are required, the softening process, in fact, in no way necessitating pumping. The space occupied by the whole of the tanks and apparatus is 60 ft. square, 3,600 ft. area, and softens 50,000 gallons per day. For the daily softening of quantities less than 1,000 gallons, the tanks are made of galvanized sheet iron, and the whole apparatus and tanks are self-contained, so as only to require the making of the necessary connections with the existing supply and delivery pipes, and fixing in place. No expensive foundations are required, and the entire cost of an apparatus--see Figs. 2, 3, 4, 5, and 6--capable of softening 500 gallons per day is about £75. Annexed is a more detailed description of the manner of fixing and working the smaller apparatus. [Illustration: Fig. 3] The tank must, of course, be set up perfectly level. The pipe from the source of supply--in the present case from the hydraulic ram--must be attached to the upper three way cock at A, on the accompanying engravings, and the pipe to supply softened water is to be connected to the lower three-way cock at B, and should be led into the elevated cistern with a ball cock so as to keep it always filled. The three ball cocks in C, D, and E should be adjusted to allow the tanks to fill to within 3 in. of the top. The nuts at the upper extremity of the three rods, F, G, and H, should be so adjusted that when the water in the several tanks has been drawn down to within 15 in. of the bottom the rocking shaft, I I, is drawn down and the vertical rod, J, lifted so as to allow the wheel, K, and spindle, L, to revolve by the action of the weight, M. The length of the chain is such that when the weight, M, rests upon the floor the face of the raised rim on the wheel, K, should not quite touch the rod, J, and if necessary, a thin packing should be put for the weight to drop upon. The lime to be used should be pure chalk lime free from clay, mixed with water to a smooth, creamy consistency, and then poured into the small tank, N. This tank should then be filled with water to within 3 in. of the top, and the small air pump worked until the lime has become thoroughly mixed and diffused throughout the water. Care must be taken that previous to filling the tank the float, O, is raised up, as shown by the dotted lines in Fig. 3. After the lime has been thoroughly mixed it should be left for at least eight hours for the superabundant lime to subside, leaving the supernatant fluid a perfectly clear saturated solution of lime. At the end of this time the float, O, should be lowered, so that it may float upon the lime water, and the three-way cock, P, should be turned in such a position as to allow the contents of the tank, N, run into the tank, Q, until the necessary quantity has been supplied, the mode of determining which is hereinafter described.