We give herewith a perspective view of the improved machine. On examination it will be noticed that an alteration is made in the motion seen at the end of the machine for working the detached rollers. This alteration we believe to be a decided improvement over Heilmann's original arrangement. It dispenses with the large detaching cam, the cradle, the notch-wheel, the catch and its spring, the large spur wheel which drives the calender roller, and the internal wheels for the detaching roller-shaft, substituting in their stead a much simpler motion, consisting of a smaller cam, a quadrant, and a clutch. The arrangement, having fewer parts, is also much more compact than the old one, for with the driving pulleys in the best position it enables the machine outside the framing to be shortened 10 in., an important point in a room full of combers. The action of this detaching motion is positive, and enables the machine to be run at a high speed without danger of missing, as happens when the point of the catch for the old notch-wheel becomes broken or worn away. Another important feature of the new arrangement is that it allows the motion of the detaching-roller to be varied. By an adjustment, easily made in a few seconds, the delivery may be altered to suit different classes of cotton or kinds of work without the necessity of changing the cams or the notch-wheels. An improvement has been made in the construction of the nippers. In the ordinary Heilmann's comber, the upper blade has a groove in its nipping edge, and the cushion plate is covered with cloth and leather, the fibers being held by the grip between the leather of the cushion plate and the edges of the groove in the upper blade, or knife, as it is called. The objections to this mode of construction were that the leather on the cushion plate required frequent renewing, and unless the adjustment was more accurate than could always be relied on, the grip of the nippers was not perfect, for while at one end the nipper might be closed, at the other end it might be open wide enough to allow the cotton to be pulled through by the combing cylinder, and made into waste. In Messrs. Dobson and Barlow's nipper there is neither cloth nor leather on the cushion plate. Its edge is made into a blunt ^, upon which the narrow flat surface of a strip of India rubber or leather fixed in the knife falls to give the nip. By this plan the cushion is applied to the knife instead of to the plate, which of course makes the cushion plate, after it has once been set, a fixture; it also dispenses with the accurate setting, as is now necessary in the old arrangement. It further does away with the frequent and expensive covering of the cushion-plate with roller leather and cloth, thus effecting a considerable saving, not only in cost of material, but also in labor, inasmuch as the nipper knives can be taken off, recovered, and replaced in one-sixth the time required to cover the cushion plates