Scientific American Supplement, No. 508, September 26, 1885 — John Shaqi
Scientific American Supplement, No. 508, September 26, 1885Various
Science
Scientific American Supplement, No. 508, September 26, 1885
Various
Science -- Periodicals
It now remains to say a few words concerning the sinking of the shaft,
which, after the operation of the dredge, was continued by the process
called "natural level" The work was not easy until a depth of 111 feet
had been reached. Up to this point it had been necessary to proceed
with great prudence, and retain the shifting earth by means of four
iron plate tubes weighing 54 tons. Before finding a means of widening
the work already done by the dredge, Mr. Chavatte was certain that he
would have to use two sections of tubbing, and so had given the first
section a diameter of 161/2 feet. He could then greatly reduce the
diameter, and bring it to 153/4 feet as soon as the ground auger was
used.
After two yards of soil had been removed from beneath the edge of the
tubbing, the earth began to give way. Seeing this, Mr. Chavatte let
down a tube 13 feet in length and 15.4 in diameter. The exterior of
this was provided with 12 oak guides, which sliding over the surface
of the tubbing had the effect of causing the tube to descend
vertically. And this was necessary, because this tube had to be driven
down every time an excavation of half a yard had been made.
Afterward, a diameter of 15.35 feet was proceeded with, and the small
central shaft of 41/4 feet diameter was begun. This latter had not as
yet been sunk, for fear of causing a fall of the earth.
Next, the earth was excavated to a depth of 8.2 feet, and a tube 16.4
feet in length was inserted; then a further excavation of 8.2 feet was
made, and the tube driven home.
After this an excavation of 261/4 feet was made, and a tube of the same
length and 141/2 feet in diameter was driven down. Finally, the shifting
soil was finished with a fourth tube 191/2 feet in length and 14 feet in
diameter.
A depth of 111 feet had now been reached, and the material encountered
was solid white chalk. From this point the work proceeded with a
diameter of 13.9 feet to a depth of 450 feet. The small shaft had been
sunk directly to a depth of 475 feet. At 450 feet the diameter was
diminished by three inches. Then an advance of a foot was made, and
the diameter reduced by one and a half inch.
The reason for this reduction in the diameter and change in the mode
of deepening was as follows:
The Chaudron moss-box, when it chances to reach its seat intact, and
can consequently operate well, undoubtedly makes a good wedging. But
how many times does it not happen that it gets injured before reaching
its destination? Besides, as it often rests upon earth that has caved
in upon its seat during the descent of the tubbing, it gets askew, and
later on has to be raised on one side by means of jacks or other
apparatus. Under such circumstances, Mr. Chavatte considered this
moss-box as more detrimental than useful, and not at all
indispensable, and so substituted beton for it, as had previously been
done by Mr. Bourg, director of the Bois-du-Luc coal mines.
Public-domain text, read in full here on John Shaqi.
Reviews
Reviews
No reviews yet
Be the first to share your thoughts on this work.
Join the Discussion
Join the discussion
Sign in to leave a comment or review.
Sign InorCreate an account