For boiler and ship plates, the mildest and most ductile steel is favored. For ships' frames and beams, a harder steel, up to 75,000 pounds tenacity, is frequently used. For tension members of bridges, steel of 65,000 to 75,000 pounds tenacity is usually specified; and for compression members, 80,000 to 90,000 pounds. In the Forth Bridge, compression steel is limited to 75,000 to 82,000 pounds. Such a marked advantage occurs from the use of high tension steel in compression members, and the danger of sudden failure of a properly made strut is so little, that future practice will favor the use of hard steel in compression, unless the material should prove untrustworthy. In columns, even as long as forty diameters, steel of 90,000 pounds tenacity will exceed the mildest steel 35 per cent., or iron 50 per cent., in compressive resistance. The present uncertainty consists largely as to how high-tension steel will endure the manipulation usual with iron without injury. A few experiments were recently made by the writer on riveted struts of both mild and hard steel, which had been punched, straightened, and riveted, as usual with iron, but no indication of deterioration was found. Steel castings are now made entirely trustworthy for tensile working stresses of 10,000 to 15,000 pounds per square inch. In some portable machinery, an intermittent tensile stress is applied of 15,000 pounds, sometimes rising to 20,000 pounds per square inch of section, without any evidence of weakness. * * * * * Equal volumes of amyl alcohol (rectified fusel oil) and pure concentrated hydrochloric acid, shaken together in a test tube, unite to form a single colorless liquid; if one volume of benzine (from petroleum) be added to this, and the tube well shaken, the contents will soon separate into _three_ distinct colorless fluids, the planes of demarkation being clearly discernible by transmitted light. Drop into the tube a particle of "acid magenta;" after again shaking the liquids together, the lower two zones will present different shades of red, while the supernatant hydrocarbon will remain without color. * * * * * A METHOD OF MEASURING THE ABSOLUTE SENSITIVENESS OF PHOTOGRAPHIC DRY PLATES. [Footnote: From the Proceedings of the Academy of Arts and Sciences.--_Amer. Jour._] By WILLIAM H. PICKERING.