To cast off a thread the proper way is to stand at a distance of about three feet from the hook previously mentioned, and by holding the end of the hemp in the left hand, pass it over the hook and bring it down with the right, then holding with the left and breaking as above. When sufficient strands to form the thread have been broken off, carefully examine the points to see that they taper properly, and have no lumps in them. Rub the wax up and down a few times, so that the thread may be properly waxed on that portion which will be inside when twisted. Hold the two ends in the left hand, and with the right roll each end separately down the right leg a sufficient number of times to twist the thread throughout. Judgment will be required in this operation, or the thread will be a constant source of trouble if it is over-twisted. Wax it again, and then it is ready for use. See that the points are well waxed, then take a needle and pass the point of the thread through the eye until it nearly reaches that part which would stop its progress. It must now be turned down on to the thicker portion and carefully twisted. Smooth it down, then take the other end of thread and another needle, and fasten it on in the same way. In selecting the awl to be used, do not take a very large one. The hole should be just large enough for the thread to require a slight pull to get it through. To commence sewing take one side and a gusset and place them evenly together, the right side of the material being inside, and fix them in the clams. Slip the welt as previously described between the edges, and pass the awl through the lot. Drive it perfectly straight, as upon this chiefly depends a nice seam when turned. Draw out the awl, and by following the point, pass up the bottom needle with the left hand. This should be taken by the thumb and forefinger of the right hand and the thread pulled through half its length, so forming a thread of equal length on each side. Make another hole with the awl about one-third of an inch from the first. This gives the length of stitch. Pass up the bottom needle as before into the right hand, the top needle descending to the bottom immediately after. Take hold of this with the left hand and pull through the threads simultaneously top and bottom, until the extremity on each side lies on and forms the stitch. Be careful that in pulling in the latter part each thread closes at the same time, thereby preventing a crooked seam. Repeat until the seam is finished, then take the other gusset and place in position. Sew this, then take the other side of bag and sew to the gussets. You will then have something in the shape of a bag, minus the bottom. Take this next, and fix each corner to one of the seams previously made, and stitch it carefully round, placing a welt in as before. At the end of each seam a stitch or two back should be taken or the thread tied over to prevent it opening.