The outside of the bag being inward, it must now be turned previous to stiffening and framing. The turning is done by placing the bag over the left arm, and with the right hand commence pushing in one of the corners, then the opposite one until that end is reversed. Then serve the other end in a similar manner, and smooth each seam along. We now take a piece of stout millboard (an old ledger book cover will do if large enough), or, if purchased with the frame, ask for a two pound board: this will cost about 4d., and be sufficient for several bags. Cut it quarter of an inch less than the bottom all round, and see that it fits before gluing it in. To do this, place one end within the seams at one end of the bag, and by lifting it in the middle press in the other, when the stiffening will lie within the four seams at the bottom. Having fitted it satisfactorily, take it out again and glue it well with some good hot glue. This must be neither too thick nor too thin. The best way to prepare it is to lay some glue in cold water for twelve hours. It will absorb sufficient water in that time, and can be boiled up without any further preparation. The quicker it is fixed after the glue is put on the better. A brush similar to a paint brush will be the best to apply it with, and need not cost more than 6d. After the gluing, lay it aside for a few hours to allow it to thoroughly set, during which time the making of the handles can be proceeded with. On some bought bags these are very common, and seldom last more than a few months; the usual plan being to take a piece of rope about the size of a clothes line and roll a piece of brown paper round it, covering it afterward with a piece of basil leather. Procure two pieces of brown harness leather--the shoulder of the hide is most suitable--from a saddler, 11 inches long by 1-1/8 inches wide, round the four ends, and make a compass mark 1/8 of an inch from the edge all round for the stitching. Take a piece of line as above, and place within the leather, which most likely will have to be damped to make it draw round easier. Leave 11/2 inches from each end for sewing to the bag, the line also being so much less than the full length of the handles. Having sewn them, flatten the ends and bend the handles into a semicircular shape, and leave them to dry. By this time the glue holding the stiffening to the bottom of the bag will be set, so the next move will be to put in the studs or nails. Take the largest size awl and make five punctures through the bottom, about three-quarters of an inch from each corner and one in the center, as in Fig 8; push the nails through and turn down each of the two claws in an opposite direction, tap them with a hammer to make them lie closer, and also to prevent them from becoming loose. This done, we next take the frame and remove the key-plate from it.