An electric contact is closed by a slight movement of the lever whenever the thread requires a new filament of cocoon, and broken again when the thread has been properly strengthened. It is evident that a delicate faller movement might be employed to set the feed mechanism in motion instead of the electric circuit, but, under the circumstances, as the motion is very slight and without force, being, in fact, comparable to the swinging of the beam of a balance through the space of about the sixteenth of an inch, it is simpler to use a contact. The actual work of supplying the cocoons to the running thread is performed as follows: The cleaned cocoons are put into what is called the feeding basin, B1 (Fig. 1), a receptacle placed alongside of the ordinary reeling basin, B, of a filature. A circular elevator, E, into which the cocoons are charged by a slight current of water, lifts them over one corner of the reeling basin and drops them one by one through an aperture in a plate about six inches above the water of the reeling basin. The end of the filament having been attached to a peg above the elevator, it happens that when a cocoon has been brought into the corner of the reeling basin, the filament is strung from it to the edge of the hole in the plate in such a position as to be readily seized by a mechanical finger, K (Fig. 3), attached to a truck arranged to run backward and forward along one side of the basin. This finger is mounted on an axis, and has a tang projecting at right angles to the side of the basin, so that the whole is in the form of a bell crank mounted on the truck. [Illustration: FIG. 3.] There are usually four threads to each basin. When neither one of them needs an additional cocoon, the finger of the distributing apparatus remains, holding the filament of the cocoon at the corner of the basin where it has been dropped. When a circuit is closed by the weakening of any one of the threads, an electromagnetic catch is released, and the truck with its finger is drawn across the basin by a weight. At the same time the stop shown dotted in Fig. 3 is thrown out opposite to the thread that needs strengthening. This stop strikes the tang of the finger, and causes the latter to be thrown out near to the point at which the filaments going to make up the weakened thread are being drawn from the cocoons. Here the new filament is attached to the new running thread by a kind of revolving finger, J, called in France a "lance-bout." This contrivance takes the place of the agate of the ordinary filature, and is made up, essentially, of the following parts: