All incubators must be kept in a warm location, whether operated by a lamp or otherwise. The warmer the room or cellar, the less warmth required to be supplied. Bear in mind that the incubator recommended has four inches of sawdust surrounding it, and more sawdust would still be an advantage. The sawdust is not used to protect against the outside temperature, but to absorb and hold a large amount of heat, and that is the secret of its success. The directions given were to first fill the tank with boiling water and allow it to remain for 24 hours. In the meantime the sawdust absorbs the heat, and more boiling water is then added until the egg-drawer is about 110 or 115 degrees. By this time there is a quantity of stored heat in the sawdust. The eggs will cool the drawer to 103. The loss of heat (due to its being held by the sawdust) will be very slow. All that is needed then is to supply that which will be lost in 12 hours, and a bucket of boiling water should keep the heat about correct, if added twice a day, but it may require more, as some consideration must be given to fluctuations of the temperature of the atmosphere. The third week of incubation, owing to animal heat from the embryo chicks, a bucket of boiling water will sometimes hold temperature for 24 hours. No objection can be urged against attaching a lamp arrangement, but a lamp is dangerous at night, while the flame must be regulated according to temperature. The object of giving the hot water method was to avoid lamps. We have a large number of them in use (no lamps) here, and they are equal to any others in results.