Referring to the valve and this engine as to how it will satisfy our requirements of a perfect valve gear, we find that the first requirement of a rapid and full opening is met, in that the opening occurs when the main eccentric is moving very rapidly, yet not its fastest, and while this opening will be very satisfactory, it is not so rapid an opening as is obtained in some other forms of valves and valve gears, but this could be overcome very readily by increasing the lead a trifle, and in my experience with these engines I find that the practice is very general by engineers and by builders themselves to give them a considerable amount of lead. As to the second requirement, the maintenance of initial pressure until cut off, giving a straight steam line, cards from this engine will not be found to show that the engine satisfies this requirement, and for this reason, that the cut-off valve commences to close the port immediately after the piston commences to move. The cut off eccentric you will remember is set to move with the crank or very nearly so, and the lighter the load, the greater will this fact appear. For the lightest loads the governor places the eccentric in advance of the crank, so that the cut off valve will commence to close the port before steam is admitted by the main valve to the engine. Now, the later the cut off, the less will this wire drawing appear at first, and the shorter the cut off, the amount of wire drawing increases sensibly. The operation of the valve, therefore, in this particular, cannot be considered as meeting our requirement that the port shall be held open full width until ready to be closed. Many men claim for this engine that the closing occurs when the cut off eccentric is moving its fastest. This is a fact, and if we consider the point of cut off only to be the point of absolute cut off, the cut off must be instantaneous, for there is an instantaneous point where the cut off is final only to be considered. The reasoning applied here would hold good also to a less extent on the slide valve, but is not the point of absolute cut off. We want to note how long it is from the time the valve commences to close at all until finally closed, and, as I have shown you, this is considerable in this engine.