The live spindle should be enlarged at the face plate end, and tapered at both ends, as indicated in the engraving. The pulleys, which are of hard wood, are made of three pieces glued together, bored, and driven on the spindle, secured by a pin passing through both it and the spindle, and turned off. The bars forming the shears may be either cold rolled iron or round machinery steel; they will require no labor except perhaps squaring up at the ends. The castings having been fitted to the bars, and provided with set screws for clamping them, the two standards that support the live spindle and the support for the opposite end of the bars are put in position, when the bars are made truly parallel, and a little clay or putty is placed around each bar and over the annular cavity that surrounds it, and is formed into a spout or lip at the upper side to facilitate the pouring of Babbitt metal. The metal must be quite hot when poured, so that it will run sharp and fill the cavity. To guard against a possible difficulty in removing the castings from the bars it might be well to cover the side of the bar next the screw with a thin piece of paper. The pieces of the tail stock and tool rest support are fitted to the bars by means of Babbitt metal, the metal being poured first in one half and then in the other. The bolts which clamp the two parts of the rest support and tail stock together are provided with lever handles. After fitting the parts to the two bars by means of Babbitt metal, the tail spindle, which is threaded for half its length, is placed in the tail stock parallel with the bars and Babbitted. A binding screw is provided for clamping the tail spindle, and the spindle is drilled at one end to receive the center, and has at the other end a crank for operating it. A steel or bronze button is placed in the hole in the standard that supports the smaller end of the live spindle, and the spindle is supported in its working position and Babbitted. The thread on the spindle should be rather coarse, so that wooden or type metal face plates and chucks may be used. The table shown in Fig. 1 is simple and inexpensive. It consists of two pairs of crossed legs halved together and secured to a plank top. A small rod passes through the rear legs near their lower ends, and also through a piece of gas pipe placed between the legs. A diagonal brace is secured to the top near one end, and is fastened to the lower end of the rear leg at the other end of the table.