For public buildings, &c., coils are sometimes used; but more often the pipes are run in grated-topped channels just beneath the floor, the grating being level with the floor-boards; they are taken around or across the building, as is most desirable to obtain an equable heat. The radiating pipes, whether single or forming coils, are generally 4 in. diameter, of cast iron (cast iron being a better conductor or dissipator than wrought), and at the highest point m the apparatus a hole is drilled and a small cock is inserted; this cock is opened when charging, to allow of the free escape of the air in the pipes, and it is sometimes of service to discharge any steam that is generated. The pipes are made with a socket at one end, into which the plain end of the next pipe is inserted and packed with yarn, &c.; but a modern and rapid method of joining the pipes is that patented and manufactured by Jones and Attwood, of Stourbridge; this joint consists of two flanges with indiarubber packing between, which makes a perfectly secure joint by tightening the flanges together; in this method the ends of the pipes are of equal size. As explained, the principle of circulation is exactly the same in this as in a domestic hot-water supply apparatus. The most popular form is that known as the Desideratum. The makers have also introduced a singularly useful tool for cutting all pipes from 2 to 13 in. diameter. _High-pressure Heating_, or which might be correctly termed steam heating, consists of piping wholly, the pipe is smaller and of wrought iron unusually strong, and a coil of it placed within the fire-box fulfils the duty of a boiler (no boiler or large container can be used on account of high pressure); from the furnace coil the pipe is carried wherever required, a small quantity of water is put within the apparatus and the air is driven out, after which the apparatus is sealed or closed air and steam tight. When the heat is applied, the water quickly forms steam, which at once finds its way throughout the apparatus and heats it to a much higher temperature than boiling water; and there is comparatively no danger whatever pressure is exerted, as at the worst the pipe only splits, and no disastrous explosion can occur; but this mode of heating cannot be recommended, as it rarely works for any length of time without requiring attention or repairs.