Unlike a locomotive, the automobile must be light, must be able to carry power or fuel enough to drive it a long distance, and yet must be almost automatic in its workings. All of these things the modern motor car accomplishes, but the struggle to make the machinery more efficient still continues. The three kinds of power used to run automobiles are steam, electricity, and gasoline, taken in the order of application. The steam-engines in motor-cars are not very different from the engines used to run locomotives, factory machinery, or street-rollers, but they are much lighter and, of course, smaller--very much smaller in proportion to the power they produce. It will be seen how compact and efficient these little steam plants are when a ten-horse-power engine, boiler, water-tank, and gasoline reservoir holding enough to drive the machine one hundred miles, are stored in a carriage with a wheel-base of less than seven feet and a width of five feet, and still leave ample room for four passengers. It is the use of gasoline for fuel that makes all this possible. Gasoline, being a very volatile liquid, turns into a highly inflammable gas when heated and mixed with the oxygen in the air. A tank holding from twenty to forty gallons of gasoline is connected, through an automatic regulator which controls the flow of oil, to a burner under the boiler. The burner allows the oil, which turns into gas on coming in contact with its hot surface, to escape through a multitude of small openings and mix with the air, which is supplied from beneath. The openings are so many and so close together that the whole surface is practically one solid sheet of very hot blue flame. In getting up steam a separate blaze or flame of alcohol or gasoline is made, which heats the steel or iron with which the fuel-oil comes in contact until it is sufficiently hot to turn the oil to gas, after which the burner works automatically. A hand air-pump or one automatically operated by the engine maintains sufficient air pressure in the fuel-tank to keep a constant flow. Most steam automobile boilers are of the water-tube variety--that is, water to be turned into steam is carried through the flames in pipes, instead of the heat in pipes through the water, as in the ordinary flue boilers. Compactness, quick-heating, and strength are the characteristics of motor-car boilers. Some of the boilers are less than twenty inches high and of the same diameter, and yet are capable of generating seven and one-half horse-power at a high steam pressure (150 to 200 pounds). In these boilers the heat is made to play directly on a great many tubes, and a full head of steam is generated in a few minutes. As the steam pressure increases, a regulator that shuts off the supply of gasoline is operated automatically, and so the pressure is maintained.