The Dutch plow was taken as a model for English plows and, in fact, for the plows of all nations. The mold-board grew rapidly into favor and by the end of the eighteenth century it was found on plows in all civilized nations. But the plow was still made mostly of wood (Fig. 10) and it was still an awkward and a poorly constructed affair. The method of making plows about the year 1800 has been described as follows: "A mold-board was hewed from a tree with the grain of the timber running as nearly along its shape as it could well be obtained. On to this mold-board, to prevent its wearing out too rapidly, were nailed the blade of an old hoe, thin strips of iron, or worn out horseshoes (Fig. 10). The land side was of wood, its base and sides shod with thin plates of iron. The share was of iron with a hardened steel point. The coulter was tolerably well made of iron. The beam was usually a straight stick. The handles, like the mold-board, were split from the crooked trunk of a tree or as often cut from its branches. The beam was set at any pitch that fancy might dictate, with the handles fastened on almost at right angles with it, thus leaving the plowman little control over his implement, which did its work in a very slow and most imperfect manner." [Illustration: FIG. 10.--A COLONIAL PLOW.] But about the end of the eighteenth century the world was beginning to need a plow that would do its work rapidly and well. Population was everywhere increasing and it was necessary to till more ground than had ever been tilled in former times. Especially was a good plow needed in the United States where there were vast areas of new ground to be broken. And it was in the United States that the first great improvements in the plow were made. Foremost among those who helped to make the plow a better implement was the statesman, Thomas Jefferson. This great man while traveling in France in 1788 was struck by the clumsiness of the plows used in that country. In his diary he wrote: "The awkward figure of their mold-board leads one to consider what should be its form." So Jefferson turned his attention to mold-boards. He saw that the mold-board ought to be so shaped that it would move through the ground and turn the sod with the least possible resistance and he planned for a mold-board of this kind. By 1793 he had determined what the proper form of a mold-board should be and had in actual use on his estate in Virginia several plows which had mold-boards of least resistance. Mr. Jefferson's patterns of the mold-board have, of course, been improved upon, but he has the honor of having invented the first mold-board that was constructed according to scientific and mathematical principles.[12] [Illustration: FIG. 11.--DANIEL WEBSTER'S PLOW.] [Illustration: FIG. 12.--JETHRO WOOD'S PLOW, 1819.]