Sweet Clover: Harvesting and Thrashing the Seed CropCoe, H. S.
Science
Sweet Clover: Harvesting and Thrashing the Seed Crop
Coe, H. S.
Sweet clover -- Harvesting
[Illustration: Fig. 1.--A self-rake reaper used in some sections of the
country for cutting the sweet-clover seed crop.]
[Illustration: Fig. 2.--A sled used in western Kansas for hauling sweet
clover from the field to the thrashing machine.]
It is the custom in some localities to leave the gavels to cure as
dropped by the reaper on the ground, while in other sections they are
placed in cocks that weigh about 300 pounds each when cured. If the
gavels are to be placed in cocks, this should be done immediately after
cutting, as the plants will be somewhat green and tough at this time
and fewer pods will shatter than when the plants are permitted to dry
before handling. When the crop is to be hauled to the thrashing machine
on wagons it is best to permit the gavels to cure as dropped by the
reaper, as it will then be possible to pitch them on the wagon with
a large 4-tined fork. If the crop is to be hauled to the thrashing
machine on large sleds, which is the practice in western Kansas, less
seed will be lost from shattering if the gavels at the time of cutting
are placed in cocks of such a size that they may be put on the sleds
entire by two men lifting from opposite sides of the cock with 4-tined
forks. The sleds used for this purpose usually are 12 by 20 foot in
size, made of matched flooring and with 6 to 12 inch sides. (Fig. 2.)
Matched or tight floors are necessary, so that all seed which shatters
may be saved. These would not be so essential, however, if the sleds
were covered with a tarpaulin or canvas. From the standpoint of saving
shattered seed, this method of hauling the crop from the field to the
thrashing machine is possibly the most economical thus far used. It
is estimated that at times as much as one-third of the seed yield is
collected from the floors of the sleds. It would be a good plan to
replace the runners of the sleds with very low trucks, as this would
lighten the draft considerably.
When sweet clover is cut with a self-rake reaper the crop is thrashed
directly from the field. From 7 to 10 days of good haying weather in
sufficient to cure the plants in the gavel or cock. Thrashing should
be done as soon as possible, much seed is shattered by rains and
winds. While a self-rake reaper is used to some extent in different
sections of the country, it is used most extensively in the western
North-Central States, and especially in western Kansas.
THE GRAIN BINDER.
A grain binder is employed extensively for cutting the sweet-clover
seed crop. (Fig. 3.) The general use of this machine in many sections
of the country is due to the fact that it is found on most farms
and therefore causes no outlay of money, rather than because of its
efficient work. It is not so efficient as the self-rake reaper unless
it is equipped with pans and guards to save the seed which shatters.
[Illustration: Fig. 3.--Cutting sweet clover for seed with a grain
binder.]
Public-domain text, read in full here on John Shaqi.
Reviews
Reviews
No reviews yet
Be the first to share your thoughts on this work.
Join the Discussion
Join the discussion
Sign in to leave a comment or review.
Sign InorCreate an account