Domestic producers of tar-acid resins for laminating are located in Delaware, New Jersey, New York, Illinois, Massachusetts, and Pennsylvania. The makers of the laminated materials are located in Delaware, New Jersey, New York, Ohio, Illinois, Pennsylvania, Indiana, and Connecticut. Their products are marketed under a number of trade names, including Micarta, Dilecto, Celoron, Formica, Textolite, Phenolite, Insurok, Spauldite, Synthane and Phenol Fibre. Imports into the United States. There has been practically no importation of synthetic resins for laminating. Imports of laminated products (rods, tubes, blocks, strips, blanks, or other forms) of which synthetic resin is the chief binding agent totaled only 215 pounds, valued at $612 in 1931 (principally from the United Kingdom); 13 pounds, valued at $71 in 1932; none in 1933 and 1934; 609 pounds, valued at $579 in 1935 from Canada, Germany, and the Netherlands; and 3,260 pounds, valued at $9,468 in 1936 from Austria, Germany, and the United Kingdom. Exports from the United States. Exports of phenolic or other synthetic resins for laminating and of laminated articles are not separately recorded in official statistics. It is known that appreciable quantities of laminated articles are exported to Canada, England, and other countries. TAR-ACID RESINS FOR SURFACE COATINGS Synthetic resins are widely used for surface coatings, chiefly because of the ease with which new types can be produced to meet special requirements and because of their uniformity. Tar-acid resin coatings may be varied in composition and properties to meet a particular purpose. Possible variations depend on the type or mixture of tar acid used (phenol, cresols, xylenols, tertiary amyl phenol, tertiary butyl phenol, phenyl phenol), whether the condensation takes place in the presence of an acid or an alkali, and on the proportion of formaldehyde used. The resin so formed may be modified with natural resins, synthetic resins of the alkyd type, fatty acids, or other materials. The almost endless opportunities for different types can, therefore, readily be appreciated. Types of resin used and the resultant coatings.