Palpation of Cervical transverses to determine laterality of the vertebra as a whole or its rotation is possible in position C and has been described under that head. Dorsals Palpation for _direction_ can be done best in position B. Use three fingers with a gliding movement along the line of the transverses, passing over several to determine which is most posterior. Then repeat the glide on the other side of the spine to determine whether the transverse corresponding to the anterior one is posterior or vice versa, showing that the entire vertebra is merely rotated or is displaced backward. Some palpaters prefer using both hands and palpating both transverses at once and there is no serious objection to this method, if confined to palpation in position B. In many cases, however, it leads to similar palpation of spinous processes, a most execrable habit. It should be remembered that with the first two Dorsals the transverse will be found in a transverse plane which would pass between its own spinous process and that above. This is also true of the last three Dorsals, while in the middle Dorsals the transverse is usually (not always) level with the tip of the spinous process of the next superior vertebra. Before adjusting, to determine the _location_ of a transverse process in order to direct an adjustment against it, first palpate spinous process and hold it with the tip of the middle finger. Then approximate with the first finger a point even with the tip of the spinous process above and about one inch from the spine--this of course in mid-dorsal. Then let second and third fingers follow the first so that all three rest on or near the transverse to be palpated. Pressing gently, but firmly, move the three fingers until the process can be felt beneath them. Hold the process with the middle finger so as to direct with it the contact of the adjusting hand to a point exactly over the transverse process. Lumbars The transverses of a Lumbar vertebra lie just even with the interspace between their own and the adjacent superior spinous process. They are deeply embedded in muscle tissue and very hard to palpate. They may vary considerably in size or length and the last one or two may be absolutely impalpable. It is sometimes advisable to adjust a rotated Lumbar by using the transverse as a lever, but this should never be attempted unless the process can be distinctly felt. The method of locating in Lumbar is practically the same as in the Dorsal region. Transverse Palpation with Patient Sitting Palpation of Cervical transverses in position A has been described and is frequently done. Palpation of Dorsal or Lumbar transverses in the same position may sometimes be desirable. It can be done with the same movement as spinous process palpation, and may serve to detect a bent spinous process.