The amount of force used in an adjustment varies so much in different spines and in different parts of the same spine that it is quite impossible to state any correct estimate of it in terms of physical units. In general the Cervicals move with least resistance, then the Dorsals, then the Lumbars, and finally the Sacrum and Ilia as hardest of all to displace or replace. In developing additional force when it is found that the force first used on any vertebra has been insufficient to move it, remember this law: _Work equals one-half Mass times the square of the Velocity_. In other words, doubling the speed of the movement increases its effectiveness four-fold; tripling it, nine-fold. The increase in force should never be effected by increasing the _weight_ or _pressure_ upon the patient’s body, for reasons which should be clear from a study of previous pages, but always by increasing the _speed_ of the movement. Names Used to Describe Movements The names herein employed to indicate certain movements, each a well-defined method of procedure for the accomplishment of some special end, are the names or descriptive terms which seem to be in the most general use at this time. Few of these movements have arrived suddenly; most of them are the result of gradual growth and evolution: so with the terms by which they are known; they have gradually become a part of the common language of the profession. Usage sanctions them, though some of them are cumbersome, unwieldy, or entirely inappropriate. [Illustration: Fig. 7. Morikubo Move. For correction of a lateral and rotated Atlas (L. A.). Pisiform contact with anterior transverse. ] SPECIAL TECHNIC MORIKUBO MOVE A movement for the correction of a lateral and rotated Atlas, indicated for use only when the Atlas is recorded as R. A. or L. A. The position of the patient’s head renders the transverse process inaccessible unless it be anterior on the side from which adjustment is to be given. Position of Patient Place two sections of the bifid bench together so as to secure the effect of a solid bench with an upward sloping front. Have patient lying on back with back of head resting firmly on bench, chin slightly uptilted. Then turn patient’s head so that it faces sidewise and rests flatly on the side of the least prominent transverse. This exposes the anterior transverse in front of the tendons of the sterno-mastoid muscle. Use of Hands Stand leaning over head of bench and carefully place the pisiform bone of adjusting hand upon the tip of the transverse process, being careful to push aside the sterno-mastoid tendons if they interpose themselves between the pisiform and the process. The fingers of the adjusting hand extend downward toward the clavicle and rest lightly, very lightly, upon the patient’s neck. With the other hand firmly grip the wrist of the adjusting hand, fitting the pisiform of the upper hand into the hollow below the styloid process of the radius. Movement