Once the orientation of the gemstone to be cut from the rough material has been determined, the stone is dopped onto a special metal dop-stick that fits into the chuck of the facet head. The chuck is tightened so that the position of the stone on the end of the arm of the facet head is firmly fixed, and the facet head is adjusted so that the first facet that is cut is the horizontal, top facet of the stone or table facet (fig. 6). The table facet is cut by grinding the gemstone on a flat cutting lap that is diamond impregnated (fig. 8). By minor adjustments of the facet head, the lapidary can precisely control the location of the table facet. As soon as the table facet has been ground to the proper size, the cutting lap is removed from the lap plate, and the polishing lap is secured in place. Many different kinds of polishing laps and polishing compounds may be used depending on the properties of the material being polished. However, one lap and one polishing compound are usually sufficient for each gem variety. After the polishing lap is secured to the lap plate, the lapidary adjusts the facet head so that the stone is in exactly the same position relative to the lap that it was during the cutting of the table facet. The polishing lap is run wet or damp with water, as is the cutting lap, and small amounts of the polishing compound are applied to the surface of the lap while the facet is being polished. The minor scratches left by the cutting process are gradually removed, and a fine lustrous polish develops on the facet. It is especially important to take care in achieving a perfect polish on the table facet, as this facet occupies a large area of the crown of the gemstone. When the cutting and polishing of the table facet are completed, the gemstone is still rough or uncut in all portions except for this single, large, polished surface. [Illustration: Fig. 7. Facet table.] Water Light Adjusting ring Post Arm Chuck Stone Abrasives DIAMOND DUST CALCIUM OXIDE LANDE-A [Illustration: Fig. 8. Grinding the table facet on a rough stone.] CHUCK DOP-STICK DOP-WAX STONE LAP The gemstone is then removed from the dop-stick by melting the dop-wax and is dopped once more so that the plane of the polished table facet is perpendicular to the axis of the chuck and arm of the facet head (fig. 9). Great care should be taken by the lapidary to insure that the table of the stone is exactly perpendicular to this axis, or the proper placing of the later facets on the stone may become very difficult. [Illustration: Fig. 9. Stone dopped to table facet.] TABLE FACET DOP-WAX STONE DOP-STICK