The A B C of Mining: A Handbook for Prospectors — John Shaqi
The A B C of Mining: A Handbook for ProspectorsBramble, Charles A.
Science
The A B C of Mining: A Handbook for Prospectors
Bramble, Charles A.
Mining engineering; Prospecting
Touchstones are useful in deciding the probable value of gold alloys.
Several pieces of the metal under examination are cut with a cold
chisel, and the fresh edges drawn over the touchstone. These streaks
are touched with nitric acid on a glass rod. Should no reaction
follow, the gold is at least 640 fine. Wipe the stone with soft linen
and try with test acid, made by mixing 98 parts of chemically pure
nitric acid with two parts of hydrochloric acid, adding 25 parts
distilled water by measure. If this has no effect, take a touch needle
marked 700, and make a similar streak on the stone samples. Compare,
and, if necessary, continue with the other needles, using a higher
number each time. An approximate estimate of the sample will soon be
obtained. Should the gold seem poorer than 640 fine, try with the
copper or silver needle. Practice and a good eye soon make this method
very certain in its results.
Retorted amalgam is likely to contain mercury. To test for it, put a
small fragment into a closed glass tube, taking care that it falls
quite to the bottom. Heat the gold over a spirit lamp, and a deposit
of mercury will soon be seen upon the colder sides of the tube above
the bottom. The tube may be broken and the mercury collected into a
globule under water.
In mining regions gold dust passes current as coin, according to what
is supposed to be its value. Occasionally counterfeit dust is offered.
The readiest means by which it may be detected are as follows: The
dust from any one district is always much alike, and any unusual
appearance should create suspicion. Try any doubtful pieces on a small
anvil, remembering that gold is extremely malleable. Test some of the
gold with nitric acid; effervescence or evolution of red fumes, or
coloration of the acid prove impurities to be present. Place two
watch-glasses (most useful in chemical tests) on paper; the one on a
white sheet, the other on a black, and with a glass rod convey a few
drops of nitric acid from the dish to each. To the glass on white
paper add a drop or two of ammonia; a blue color would indicate
copper. To the other add hydrochloric acid; should a white precipitate
form, it proves silver. If no action is noticed, even after heating
the dish, the dust is genuine. As "dust" is sometimes merely copper
coated with gold, the better plan is to cut all the larger grains in
two, so that the acid may attack the copper should it be present.
Copper. Copper is a very easy mineral to test for. First crush the ore
and dissolve it in nitric acid by heating. Then dilute with some
water, and add ammonia. The solution should turn dark blue. The
carbonate ores of copper do not extend deep in the mine. Their places
are taken by copper pyrites. Sulphide ores are usually difficult to
treat, and when they are to be tested it is better to roast them
before trying the tests for color.
Test for copper may also be made as follows:
Public-domain text, read in full here on John Shaqi.
Reviews
Reviews
No reviews yet
Be the first to share your thoughts on this work.
Join the Discussion
Join the discussion
Sign in to leave a comment or review.
Sign InorCreate an account