The American Agriculturist. Vol. II. No. XI, December 1843: Designed to Improve the Planter, the Farmer, the Stock-breeder, and the Horticulturist — John Shaqi
The American Agriculturist. Vol. II. No. XI, December 1843: Designed to Improve the Planter, the Farmer, the Stock-breeder, and the HorticulturistVarious
Science
The American Agriculturist. Vol. II. No. XI, December 1843: Designed to Improve the Planter, the Farmer, the Stock-breeder, and the Horticulturist
Various
Agriculture -- Periodicals; Agriculture -- United States -- Periodicals
_Crown, or Bark-Grafting_ is a very ready method of grafting upon
large, uneven, old stocks and branches. It is practised somewhat later
than the methods above described, that is, from the end of March to the
third week in April, because, in that period, the separation of the
bark from the wood is more easily affected; a circumstance of primary
importance in this case. The tree is to be headed down, the cut being
made horizontally, and the section bored quite even and smooth; then
make a slit in the bark two inches in length, next with the handle of a
budding-knife, carefully open the bark for about a quarter of an inch;
then cut the scion about two inches in a sloping direction, in the form
of a tongue, leaving the bark entire on the outside. The scion thus
prepared, is pressed downward between the bark and the wood as far as
the incision in the stock extends; the bark of the stock readily yields
to the pressure employed, and the scion is supported in its situation
by a few coils of bass-matting, the whole being surrounded by clay.
_Dove-Tail Grafting._--This is a very neat and successful mode of
grafting, originating with Mr. Malone, who gives the following
directions for its performance. The scion is to be selected so as to
have two or three buds above where the knife is to be inserted to
prepare it for the operation; a slip is cut off the end of the scion,
sloping it to the bottom as long as it may be decided to insert it into
the stock. On each side of the cut, as far as it extends, a part of the
bark is to be taken off, leaving the under part broader than the upper,
on which upper or back part always contrive to leave a bud. The stock
or branch to be worked is thus prepared: Being first cut off smooth and
straight, two parallel slits, distant from each other nearly the width
of the scion and the length of its cut part, are then made in the bark
of the branch, observing particularly to slope the knife, so that the
under edge of the cut next the wood may be wider than the outer edge.
The piece of bark between the slits must then be taken out, separating
at the bottom by a horizontal cut. The scion will then slide into the
dove-tail groove thus formed, and, if the work is well performed, will
fit neatly and tightly. A small quantity of the grafting-clay must then
be carefully applied, securing it on with list, or any other convenient
bandage, fastening it at the end with two small nails. The top of the
stock should be entirely covered with clay, sloping it well up to the
grafts, and should be examined often to see if any cracks or openings
appear, which should be immediately filled up with some very soft clay.
The proper time for performing the operation is from the beginning
of April till the middle of May, or earlier if the sap is in motion.
(Gardener's Magazine, Vol. VII.)
[Illustration: BUDDING.--(FIG. 60.)]
Public-domain text, read in full here on John Shaqi.
Reviews
Reviews
No reviews yet
Be the first to share your thoughts on this work.
Join the Discussion
Join the discussion
Sign in to leave a comment or review.
Sign InorCreate an account