Since the introduction of the wood hive by Mr. Woodbury, that gentleman has recommended, in the _Journal of Horticulture_, that the stock-hive be made of straw, of exactly the same dimensions; this material being wanner in winter, slightly ventilating, and allowing of absorption. Bees, during cold weather, cluster together to generate the requisite degree of heat; the temperature of the interior of the hive being thus so much higher than the external atmosphere, a good deal of moisture condenses at the top and on the sides of the hive. The straw, as before stated, prevents this dampness hanging about the hive, and tends to keep the inmates more healthy. Dampness in a hive is a fruitful source of mischief, causing empty combs to grow mouldy, and is injurious in many ways. The square straw hives, and a machine for making them, exhibited in the Austrian department of the International Exhibition of 1862, suggested the idea of employing that material for English bar and frame hives. We have had a machine made somewhat similar to the one exhibited, and suited to the size of our hives, by which our hive-maker is able to manufacture neat square straw hives. These have a wood frame at top, an inch deep, with the requisite notches to allow the ten-comb frames to hang. A similar frame forms the base, the straw being worked between. The floor-board is one and a quarter inch thick, "keyed" with stout keys, as before mentioned. An inch projection is left on all sides beyond the exterior of the hive, from which it is slightly chamfered down. An entrance, four inches wide, is cut out of the substance of the board, beginning at the edge, and continuing on the same level until inside the hive, where it slopes upwards. This entrance is about three-eighths of an inch high where the hive crosses it.