Every boy should have a box of tools, and a bench to work at, also a little room or loft for a workshop. He ought to obtain good tools, and by no means buy the boxes of rubbish sold to boys for their amusement. He should go the ironmonger's and purchase the following tools; of course, out of his own savings,--his own pocket-money,--and not apply to his parents for it. Two saws, one small and one hand-saw. Four gimlets of different sizes. One pair of pincers. One pair of plyers. Four chisels of different sizes. One gouge. Two hammers, large and small. One mallet. Two bradawls. Two planes, long and short. Two flies, large and small. One level. One square. One screw-driver. Nails, screws, rings, glue-pot, hone, oil, etc. He must also manage to obtain a carpenter's-bench, which he cannot very well do without, and then he may begin carpentering with expedition. USES OF THE VARIOUS TOOLS. THE SAW.--Before a saw can be used after it is purchased, it generally has to be "set," as it is termed; that is, its teeth are to be sharpened and placed a little outwards from the plane of its length. There are several kinds of saws, namely, the common hand-saw, the key-hole saw, and the small-toothed saw. The first is to cut planks and thick pieces of wood; the second is to cut holes in planks or boards; the third is to cut small pieces of wood, or those that require to be very nicely divided. THE PLANE.--The plane is used to smooth boards with. There are several kinds of planes. The long plane and the short plane are the principal ones. Within the plane is the knife, which is fastened in by a knock of the hammer on the wedge inside, which is made so as to fix the edged knife at any distance from the bottom of the plane, either for thin or thick shaving. A very little direction from the carpenter will enable the young carpenter to fix his knife properly; and a knock on the end of the plane with a hammer will loosen it in a moment. The knife should be sharpened from time to time on the stone or hone. This should be done with great care, so as to preserve a proper angle at the edge and great evenness in every part, otherwise, the planing will be very imperfect. In planing, the wood to be planed is either laid flat on the bench, with its end against the little pin, to prevent its moving, or fixed in the screw of the bench, and the plane being brought upon the top or edge of the wood, is pushed carefully, but somewhat sharply along. The shaving comes through the hole in the plane, and must be cleared away, from time to time, out of the way of the knife. Everything planed should be planed perfectly level, smooth, and even. [Illustration]