In preparation for the assembling of the different parts, the tube is the forging to be finished. It is bored and turned to exact dimensions and carefully “bore-searched” and “star-gauged.” With the data at hand a sketch is made showing the external diameters of the liner under the tube, due allowance being made for the shrinkage when assembling. The liner is next bored to within .35 of an inch of the finished diameter, and turned to the dimensions required by the sketch above. This extra metal in the bore is left until the gun is completely assembled and is removed in the finish-boring. The liner is then carefully “bore-searched” and “star-gauged” and liner and tube are ready for assembling. The liner is now taken to the shrinking pit and carefully aligned in an upright position with the breech end down. The shrinking pit is merely a well of square section with room enough to permit workmen to move freely about the gun when it is in position, and equipped with a movable table at its bottom upon which the gun rests. In the meantime the tube, with breech end down, is being heated in a hot-air furnace. This furnace is a vertical cylinder built of fire-brick and asbestos and so constructed that air which has been passed in pipes over petroleum burners can enter at the bottom, pass around and through the tube and out through the top to be reheated. This service permits a uniform heat to be transmitted to the tube and when the desired temperature has been attained the tube is lifted from the furnace by a crane, carried to the shrinking pit and carefully lowered over the liner. Great care must be exercised in this operation to prevent the tube from sticking while being lowered into place. Should it happen, the tube should be hoisted off at once, allowed to cool, any roughing of the liner be smoothed off, the tube reheated and a second trial made. When the tube is properly in place a cold spray may be turned upon any particular section where it is desired the tube should first grip the liner. The tube is then left to cool by itself, but cold water is constantly circulating through the liner. When the gun is sufficiently cool for handling purposes, it is hoisted out of the shrinking pit and taken to the shop for careful measurement, the liner being “star-gauged” to note the compression due to the shrinking on of the tube. The same procedure is followed in the case of the jackets and hoops, until the entire gun is assembled. The gun is considered completely “built-up” when the last hoop has been shrunk on and is now ready to be finished. The gun is now finish-bored, as .35 of an inch of metal was left in the liner in the first boring. “Packed bits” are used and the greatest care is exercised to keep the bit properly centered and running true. After this step the gun is finish-turned and the powder chamber is bored.