The introduction of a finer paper rendered necessary a finer instrument of writing, and the quill of the goose, swan, and, for very fine writing, of the crow, was found to be well adapted. Immense flocks of geese were raised, chiefly for their quills. The earliest specific allusion to the quill occurs in the writings of St. Isadore de Seville, seventh century, although it is believed to have been in use at an earlier period. The quill was used for many centuries. Most of the writing during its reign was done in the monasteries by the monks, and in the eighteenth century, when quill-making became quite an art, every monk and every teacher was expected to be proficient in the art of making a pen from a quill. The preliminary process of preparing the quills was first to sort them according to their quality, dry in the hot sand, then clean them of the outer skin, and harden by dipping in a boiling solution of alum and diluted nitric acid. During the last century many efforts were made to improve the quill, its great defect being speedy injury from use. Ruby points were fitted to the nib, but this was found impracticable on account of the delicacy of the work. Joseph Bramah devised, in 1809, a machine for cutting the quill into separate nibs for use in holders, thus making several pens from one quill and anticipating the form of the modern pen. [Illustration: THE STEEL TUBE PEN] [Illustration: THE FIRST STEEL PEN] The quill held sway as writing instrument for many years, and with it the greatest masterpieces in literature have been written. Many attempts, however, had been made to supersede the quill by a pen not so easily injured by use, but it was not until about 1780 that, after much experimenting and numerous failures, Mr. Samuel Harrison introduced the first metallic pen. ~THE INVENTION OF THE PEN~ This pen was made as follows: A sheet of steel was rolled in the form of a tube. One end was cut and trimmed to a point after the manner of the quill, the seam where both edges of the tube met forming the slit of the pen. This was soon after improved upon by cutting a rough blank out of a thin sheet of steel, which blank was filed into form about the nib, rounded, and with a sharp chisel marked inside where the slit was to be in the finished pen. After tempering, the nib was ground and shaped to a point suitable for fine or broad writing, as required. [Illustration: THE MODERN STEEL PEN] [Illustration: THE MODERN WRITING PEN] Once started, the steel pen made rapid strides in improvement. Mr. James Perry, in 1824, started in England the manufacture of pens on a large scale, and to him as well as Gillott is due the many improvements which followed. Perry was the first to manufacture “slip” steel pens, up to this time the pen and holder being one piece. “In times of yore, when each man cut his quill With little Perryian skill; What horrid, awkward, bungling tools of trade Appeared the writing instruments, home made!”