Glass-blowing requires great practice and manual dexterity, for the material used being red-hot cannot be touched with the hands, and has to be very rapidly worked, or it becomes cooled and hard; to any one unused to work with it, it is the most unmanageable material conceivable, but by practice the glass-blower contrives to produce almost any form required, and of a size quite astonishing--as, for instance, the globular bottles seen in druggists’ windows, which often hold twelve gallons, also glass shades, which are of an uniform thickness, and two or three feet high. This is all done by means of a hollow rod of iron called a “puntil,” on the one end of which a mass of molten glass is collected (fig. 1), and the workman blows into the other, at the same time turning the tube rapidly round in his hands (fig. 2). When the kind of glass called “crown-glass” has to be made, the end of the iron tube is put into the pot of melted glass, and turned round till a ball of it is collected about the size of one’s head, the workman then blows in at the other end, still turning the rod in his hands; it has now the appearance presented at fig. 3. An iron rod is stuck on to the side of the globe opposite to the “puntil,” which is then pulled suddenly away, leaving a round hole. The globe of glass is again made red-hot, and spun round rapidly, the hole increasing in size until it resembles fig. 4. By continuing the rapid twirling of the rod, the hole opens wider and wider till at last one broad sheet is produced; it is then separated from the rod by putting a drop of cold water at its junction with the glass, which causes it to crack across at that part. It is now about six feet in diameter, perfectly round and flat, and when cold it is cut into halves and packed with straw in a “crate” for carriage. The knot of glass often seen in kitchen or stable windows, is the part in the centre of the glass where the iron rod has joined it, and is called the “punty.” Illustration: FIG. 5. (‡ ELONGATED BLOW GLASS.) Sheet-glass is commenced in the same way as crown, but instead of a hole being made the blowing is continued till a great round ball is formed, the rod and this ball are then swung round at arm’s length--a hole being sunk in the ground for the purpose--which causes the globe to become elongated, as in fig. 5. It is then laid upon an iron table, and rapidly slit up, the compressed air escaping from within opening it out into a broad sheet, which is instantly cut square while yet soft. Illustration: PLATE GLASS CASTING. BRINGING OUT THE POT. Illustration: FIG. 6. (‡ GRINDING THE PLATE GLASS.)