In those parts of the building more than two storeys in height, the second horizontal tier of girders does not support a gallery, but serves only to give stiffness to the columns. The upper tier of girders, in all cases, supports the roof, which is one of the most peculiar features in the structure. In its general form the roof is flat; but it is made up of a series of ridges and furrows, the rise and fall of which is but small, and is thus arranged: the roof-girders or trusses being twenty-four feet apart, and lying in the transverse direction of the building, the space between them is spanned by light beams or rafters, which are cambered or bent upwards, and are hollowed out in a groove on the top to form a gutter. The rafters are placed eight feet apart, their ends resting on the roof-girders, and lying, therefore, in the opposite direction to them, that is, in the direction of the length of the building; these rafters are commonly called the Paxton's Gutters. Between the rafters so described, _ridges_ are supported by light sash-bars sloping up to them, at an inclination of two-and-a-half to one, and the rafter itself forms the bottom of the _furrow_. The advantage of this form of roofing is the facility it affords for the escape of the water, which runs from the surface of the roof into the Paxton's gutters; from them it is discharged into the main gutters resting on the roof-girders, by which it is conducted to the hollow columns, and passes down through them into the drains. A drop of water falling on the most distant point from the discharge would only have to traverse a distance of forty-eight feet; but in most cases the length to be passed over before reaching the down pipe would be considerably less.[5] The covering of the roof is glass, fixed between the sash-bars, which are grooved to receive it; and in order to carry off the moisture arising from condensation on the inner surface of the glass, the rafters have a small groove on each side, which makes the Paxton's gutter complete, and from which the moisture is also discharged into the main gutters. The essential portions of the roof may therefore be considered as a network of gutters; one set, the main gutters, lying in a transverse direction, and the others resting on them, and lying in the direction of the length of the building; by which arrangement any amount of surface can always be covered by roofing of a small span. The principle is precisely the same as that of subdividing large fields of arable land into strips or "lands" with furrows between them, in order to facilitate the surface-drainage. [Illustration: VIEW OF ONE 24-FEET SQUARE BAY OF ROOF PARTLY COMPLETED.]