Two principles underlie the methods which are in use for this purpose. The first principle and the one on which the oldest method is based is the abstraction of the whole of the grease, etc., from the wool by means of an alkaline or soapy liquor at one operation. This cannot nowadays be considered a scientific method. Although it extracts the grease, etc., from the wool, and leaves the latter in a good condition for after processes, yet with it one might almost say that the whole of the soap or alkali used, as well as the wool grease itself, is lost as a waste product; whereas any good process should aim at obtaining the wool grease for use in some form or another. The second principle which underlies all the most recent methods for extracting the grease from the wool, consists in treating the fibre with some solvent like benzol, carbon bisulphide, petroleum spirit, carbon tetrachloride, etc., which dissolves out the cholesterine and any other free fatty matter which is in the wool fibre, leaving the latter in such a condition that by washing with water the rest of the impurities in the wool can be extracted. By distilling off and recondensing the solvent can be recovered for future use, while the wool fat can also be obtained in a condition to use for various purposes. This is rather a more scientific method than the old one, but it has not as yet come into extensive use. #Wool Scouring. Old Methods.#--In the early days of wool scouring (p. 017) this operation was done in a very primitive fashion, generally in a few tubs, which could be heated by steam or otherwise, and in which wool was worked by means of hand forks. These primitive processes are still in use in some small works, especially where the wool is dyed in the loose condition, but in all the large works machinery has been adopted, which machinery has been brought to a high state of perfection, and does its work very well, and without much attendant manual labour. The alkaline substances used in this process of scouring demand some notice. These comprise soda ash, soda crystals, caustic soda, silicate of soda, potash, caustic potash, soaps of various kinds, stale urine, ammoniacal compounds. Which of these may be used in any particular case depends upon a variety of reasons. Potash is the best alkaline agent to use. It agrees better with the fibre than any other, leaving it soft and elastic. Ammonia is the next best, but it does not take out the grease as well as the potash. Soda does not suit as well as potash, as it has a tendency to leave the fibre harsh in feel and somewhat brittle, yet on account of its being so much cheaper it is the most largely used. The use of silicate of soda cannot be recommended, as it has a great tendency to leave the fibre hard, which may be ascribed to the deposition of silica on the fibre.