Another advantage in drawing directly upon the transfer paper is that the draughtsman can make corrections pretty easily for, if needs be, a bad piece of work can be entirely cut out and a fresh piece of paper inserted. Assuming that the transfer method has been employed, the stone must be prepared according as the drawing is made with ink or with crayon. The stone is first thoroughly ground, in order to rid it of all traces of previous work, and then polished for ink work or grained--_i.e._ roughened--for crayon work, the small points produced taking up the crayon in proportion to the amount present on the transfer and the pressure used. The transfer is then damped with water, sometimes with a dilute solution of nitric acid, and placed in position on the stone, which is then passed two or three times through the lithographic press until dry. Then the back of the paper is damped and the sheet peeled off. The stone is next proved, _i.e._, prepared for printing. It is first carefully examined for broken lines and other blemishes, which are touched up with ink or crayon. The stone is then painted over with a solution of gum in water which is allowed to dry, it is then washed in water and rolled up with ink. The drawing will now be clearly visible, for if properly inked the clear parts of the stone will not take the pigment, so that any parts which require cleaning up may be deleted. This is accomplished by means of a pencil of snake stone, a piece of pumice stone, an acid stump--a rod of hard wood, the sharpened end of which is dipped into nitric acid--or with a scraper. The stone is again washed and rolled up strongly with ink and etched with a dilute solution of nitric acid which is applied with a sponge; then the surface is again gummed and the stone allowed to dry. It is sometimes necessary to re-etch the stone; if so, the damp stone is rolled up with thin ink and allowed to dry, it is then dusted over with finely powdered resin, the superfluous resin is removed by means of a wet sponge, and the surface is painted over with a solution of gum arabic mixed with dilute nitric acid. If the resin is well incorporated with the ink, the work will suffer no damage in the process. The acid gum is then dabbed off with a rag, the stone is cleaned up with turpentine, rolled up once more, gummed and finally set aside to dry. All this appears complicated, but it is very necessary to get a good surface for printing. The action of the gum does not appear to be clearly understood, the nitric acid obviously will etch the stone, so that the gum will easily penetrate. It is sometimes supposed that the arabic acid of the gum enters into a chemical composition with the calcium carbonate, making a film which is the real ink-resisting surface. This film has not a long life, so that in printing it is necessary to renew it periodically by the application of gum solution.