[Illustration: _Figure 34. Factory-packed parachute equipment PG-100/CB, containing pigeons._ TL70203] _b._ INSTRUCTIONS FOR USE. To insure safe delivery of the pigeons, caution must be observed when attaching containers to the parachutes. [Illustration: _Figure 35. Parachute laid out on flat surface._ TL70204] [Illustration: _Figure 36. Parachute folded lengthwise._ TL70205] [Illustration: _Figure 37. Parachute folded into pack._ TL70206] [Illustration: _Figure 38. Parachute pack tied and static line attached._ TL70207] The instructions printed on each parachute pack should be strictly adhered to. _c._ RESULTS. Best results will be obtained when pigeons are launched between the altitudes of 200 and 1,000 feet with air speed not exceeding 125 miles an hour. Pigeons launched within these general limits are less likely to become lost because of excessive drift. The possibility of injury to the birds from high speed air rushing through the container, or from shock when the parachute opens, will be reduced to a minimum. _d._ INSTRUCTIONS FOR REPACKING PARACHUTES. The following method is suggested for repacking either 6- or 9-foot parachutes for future use after they have been used once for dropping pigeons to ground troops. (1) Stretch parachute full length, with one man holding the canopy at the center of the top and another man holding the shroud lines taut at the shroud line separator disk. Straighten all shroud lines, making sure none are twisted. Lay the parachute on a flat surface and pick each fold of the canopy as one would pick petals from a flower, dividing the folds and associated shroud lines equally on each side (fig. 35). Eliminate creases by running the hand between the folds. (2) Make an “S” fold in the canopy lengthwise from the crown (fig. 36). The hem will form a large letter “S” if the fold is made properly. (3) Lay the shroud lines in small “S” folds on the canopy starting approximately 10 or 12 inches back from the hem, making a sufficient number of folds to bring the shroud line separator disk close to the hem of the canopy. The parachute is now ready to be folded into a pack. To do this, make three accordion folds in the canopy (fig. 37). (4) Tie the folded canopy in position with two tie cords of not more than 15 pounds strength. Place one cord approximately 2-1/2 inches back from the hem and the other cord 2-1/2 inches from the end of the pack. Attach the static line to the tie cord near the end of the pack, leaving enough tail for another tie to be made to the other tie cord near the hem with 3 inches of slack left between the two ties (fig. 38). The static line must have a tensile strength of at least 200 pounds and be 15 feet long. The 3 inches of slack left between the two ties are necessary for each tie cord to receive a sharp individual snap; otherwise both cords will break simultaneously.