There is no doubt that the Filipinos have learnt a certain amount from the Spaniards as regards their manufactures; but, on careful consideration, I think they have learnt more from the Chinese. Their first sugar-mills were Chinese and had granite rollers, and from them they learnt the trick that many a moulder might not know, of casting their sugar-pans in a red-hot mould and cooling slowly and so getting the metal extremely thin yet free from defects. The casting of brass cannon and of church bells has been learnt from them, and doubtless they taught the Igorrotes how to reduce the copper ores and to refine that metal. Again, the breeding of fish, an important business near Manila, and the manufacture of salt round about Bacoor comes from them. I am not sure whether the hand-loom in general use is of the Chinese pattern, but I think so. Distilling the nipa juice is certainly a Chinese industry, as also the preparation of sugar for export. This is done in establishments called farderias, and is necessary for all sugar made in pilones or moulds. The procedure is described under the head of Pampangos, and an illustration is given of the process of drying the sugar on mats in the sun. Many native men and women and numbers of Chinese coolies are employed in Manila, Ilo-ilo, and Cebú in preparing produce for shipment. The hemp used to come up from the provinces loose or merely twisted into rolls to be pressed into bales at the shipping ports, but of late years several presses have been erected at the hemp ports in Southern Luzon and on the smaller islands. There are a number of hemp-presses in Manila, each requiring about sixty coolies to work it, and one or two clerks to attend to the sorting and weighing. They were paid so much per bale pressed. Steam, or hydraulic presses, would long ago have been substituted but for the fact that the clerks or personeros were each allowed one or two deadheads on the pay list, and this was so profitable to them that they strongly opposed any changes, and none of the merchants cared to take the risk of the innovations. Two presses were set in line, astride a pair of flat rails, a small one called the Bito-bito for the first pressure on the pile of hemp, and the large one to squeeze down the bale to its proper size. They were simply screw presses having hardwood frames set deep into massive stone foundations and surrounded by a granite pavement. A pair of these presses, i.e., a Bito-bito and a press erected in Manila under my direction in 1888, cost $4400, the woodwork foundation and pavement costing $2850, and the screws, nuts, capstan-heads, etc., costing $1550. The small press had a screw 4 inches diameter and 6 feet long, and was worked by two or four men. The large press had a screw 8 1/4 inches diameter, and 12 feet long.