For pen work one must not be too particular in selecting stones, as the less perfect ones are more available for this than for any other method. However, the general rule holds good here, too, that the purest and hardest stones are best. If they have been used previously, so that the fatty inks have penetrated pretty well, they still need not be ground too deeply, but it will suffice to grind them merely till all depressions and elevations of the previous design have vanished. They may be ground with sand or pumice, so long as they are made smooth so that no roughness can be perceived. The smoother and finer the surface is, the easier will it be to work on it with the pen. To design well on stone with chemical ink, the stone must be prepared after grinding so that the ink shall not flow and spread. Dissolve one part of tallow in three parts of oil of turpentine and coat the dry stone very quickly. With a clean rag or tissue paper wipe it at once so thoroughly that the coating vanishes again almost entirely, leaving only a thin film that can be easily devoured and removed when the etching fluid is applied later. It is well to do this some hours before beginning work on the stone, partly to give the turpentine odor time to evaporate and partly because it is easier to work after a little while than immediately after coating the stone. The stone can be prepared far in advance, even so long as some months before using. In that case it is necessary merely to clean the dust away with a cloth or fine brush. This should be done anyway at intervals during the work, or it will clog the pen. I prefer another way of preparing the stone for designing, because it is one that insures the stone against containing any hidden preparation, which can easily occur in grinding owing to carelessness or uncleanliness on the part of the workman, especially if many old plates are being reground, when the gum which most of them contain from previous use will mix with water during grinding and thus form a partial preparation of the stone. I coat the plate with strong soap-water containing many soapy particles, and dry it off as well as possible. Now, there will be too much alkali on the plate, which will not be good for fine work. I pour a few drops of clean water on the stone, make it quite wet with this and dry it again thoroughly. The fat of the soap will then have precipitated itself on the stone and at the same time has lost all alkali. The soap-water must not be too thin, as in that case it will precipitate too much fat on the plate at once and the etching fluid will not be able later to destroy it properly. This would mean the total destruction of the design. To make quite sure, I advise beginners, after applying soap-water and drying it, to coat the stone with the tallow and turpentine solution, clean it quickly, and thus be absolutely assured that the plate is thoroughly prepared for the design.