It must not be imagined that this preparation for work is not very important. I am convinced that less depends on the quality of the ink than on a surface freed from all acid and mucous substances and provided with a sufficient amount of fat. On the stone thus prepared the rough design may be done with lead crayon or red chalk or by tracings or transfers. Any surplus of lead or red chalk would make trouble during the succeeding completion of the design with chemical ink, and must be removed carefully. If the design has been laid on by transfer, the resultant fattiness must be lightly rubbed away with a fine sand, but not so as to injure the design. This method, of first drafting the design on paper with soft chemical transfer ink and then transferring to stone, offers such advantages that it pays to practice it. Care must be taken to remove all surplus of color, as otherwise all lines that should not appear will resist the etching fluid and gradually show again. Those who fear destruction of the design by the use of sand can effect the same purpose by printing off on clean waste paper a few times, or the design may be printed off on paper before being transferred, thus cleansing it of surplus fat. When the design has been laid on the stone clean and strongly with chemical ink, the plate can be etched and prepared, but not till the whole design is perfectly dry, because otherwise it cannot resist the action of the fluid. The parts finished first usually are dry long before the entire work is finished. A trained eye can recognize the proper degree of dryness from the sheen, which varies with different kinds of ink, but on the whole is always duller when the design is dry than while it still is wet. It is highly necessary that the design be thoroughly dry. It is possible to keep a designed plate for years without etching it, so long as it is protected against injury. Etching is done in two ways, painting the fluid on and pouring it on. The former method is less circumstantial, but is used only in coarser work, because there is always danger of damaging delicate parts of the design. It has the advantage, however, that any dirt caused by corrections will be removed. A mixture of three or four parts of water with one part of aquafortis is painted over the stone with a soft brush of fox- or badger-hair. The brush must be dipped continually because the fluid loses its power. For the second method the stone is placed in a large wooden trough or box, provided with cross-pieces to keep the stone from the bottom. The acid, thinned down with thirty or forty parts of water, is poured over it. It is rather immaterial how much one may dilute the acid. Very weak solutions simply mean that the pouring must be repeated oftener. The fluid acts on stones according to their degree of hardness. Regard must be had, too, to the delicacy of the design, very fine lines being unable to resist etching that does not affect coarse lines.