(6) A stone plate may be etched so that it will have the roughness needed for crayon work. Grind it as clean and smooth as possible with pumice, pour aquafortis over it and coat with gum. Wash it well in water and dry with a clean cloth. Coat it very thinly but uniformly with tallow into which is mixed a little lampblack, so that one can see if the coating is perfectly even. With a small ball or roller covered with fine cloth, roll or pat the stone till it has a very uniform tone. Now pour a little diluted aquafortis on one end as a test to see if it penetrates uniformly through the fatty coating. Practice is needed to hit just the right thickness that the tallow coating must be. It must be thin, and yet sufficiently thick to resist the aquafortis somewhat, so that it yields only at those places where the roughness of the cloth on the roller has removed it more or less. If the test is satisfactory, make a raised border of wax around the stone and pour the aquafortis solution on it. A solution of forty parts of water to one part of aquafortis is better than a stronger one because the stones are more equally attacked. As soon as the resulting bubbles are as large as the head of a small pin, the etching fluid is poured away quickly and replaced with pure water to get rid of the bubbles. Pour away the water and apply etching fluid again. Repeat this four or five times, according to the grain desired, and in the end wash the stone well with oil of turpentine to remove all fattiness. Then it must be washed with weak but very pure aquafortis, followed by a great deal of very pure water. After cleaning and drying very carefully with a clean rag, it is ready for use; and if the work has been well done, a grain will have been produced that is prettier and much more even than can be produced by rubbing with sand. (7) The instructions given here teach how to draw on a stone that has been prepared beforehand with aquafortis and gum. This is not in the least inimical to the durability of the design if only the union of the gum with the stone has been destroyed again by washing afterward with diluted but pure aquafortis and every trace of this acid again has been removed by copious washing with pure water. If there is a considerable amount of the soap in the crayon, the good result will be greater than with an entirely clean stone, because, since it has already been etched twice, the etching after the design may be very limited, so that it is not harmful to even the most delicate shadings in the design. (8) Some attempts made by me to etch crayon designs more powerfully than usual proved that the more delicate places would suffer, but if I rubbed them up with a flat knife as described before, they appeared again and I had the advantage that the whole plate was much better prepared than it is with weak etching.