The stone must be absolutely dry before any work is done on it. Then the design is traced on it, or drafted directly on it with lead. Transfer by printing from paper is not advisable, because the resulting fattiness of the design makes the graver slip. For the actual work of engraving there is no counsel to be given except to choose good and sharp needles of the very best steel, hard enough to cut glass; and that all lines must be graved clean. There must be no excessive pressure, and in wide strokes there must be no excessive depths. In making very fine lines the stone should merely be touched by the tool. If they appear white, and a little fine dust is observed, one may be certain that they will appear properly in the printing. Broad lines often can be made with one stroke of a flat needle, but generally they are made by continued, gradual scraping. If the stone is to be only lightly wiped during printing, the broad lines must not be deeper than strictly necessary to make them clear, as otherwise they will squash. In true art works, however, which are to be printed with firm color and under more powerful rubbing and wiping, the depths of all lines must be considered carefully, as they will print darker or lighter according to depth. Of all things the worker must take heed against touching the stone with dirty or greasy hands, for a plate thus blemished is not only difficult to engrave, but the grease finally may penetrate through the slightly gummed coating and enter the stone, making much consequent trouble when the printing begins. It is more harmful still to wet the stone in any way, because then the coating gum will dissolve, penetrate into the engraved lines and give them a preparation, so that they cannot take color afterward. Therefore, especially in winter, a very cold stone must be warmed before working on it with the design, as otherwise the moisture in the room will precipitate itself on the stone. Even the perspiration of the hands or the moisture of the breath may cause damage. Therefore a good but careful warming is very advisable. If a plate has become moistened, as, for instance, from a breath, it must be permitted to dry before doing any further work on it, and especially it must not be wiped. The dust resulting from the engraving is to be removed either with a soft brush or by blowing it away. Faulty lines that are noticed during the engraving may be scraped flat very carefully so that no furrows are made, or they may be rubbed off with fine pumice, after which those places must be prepared again, and coated with gum applied with a small brush. Then the corrections can be made. If only tiny places are faulty, they need merely be coated with a mixture of weak phosphoric acid, gum, and lampblack or red chalk. This prepares them. Thus they will not take color during the print, and so are practically removed.