When the design is dry, the whole stone is inked with printing-color, care being taken that not a drop of water touches it before it is perfectly black. Then a little water is poured on, after which there must be a little more rolling with the ink-roller till all the design that is drawn with the preparing-ink is very white and clean. Now the stone can be used for printing, being used in the manner used for pen work. To make the design more durable, that it may not in time thicken in its finer parts, the stone may be well inked-in with acid-proof ink and after a few hours, during which it draws together well, the drawing is etched in intaglio with aquafortis. Then it is coated with gum and the printing is not likely to damage the design. Here we have an intaglio design which is prepared and prints white. The case may be reversed, and the black plate may be made white again while the design will print black. This is because a stone treated with preparing-ink gives almost the same result, once it is grounded with acid-proof ink and etched as if the design had been engraved into etching-ground. The etched lines need simply be filled with chemical ink as in engraved work, to make them take color instead of coating them with gum. Then there remains only the obstacle that the stone is not prepared over its whole surface and takes color everywhere. However, it is not difficult to clean the plate and prepare it perfectly, especially if the stone is finely polished. It must be rubbed well with color, and wiped clean at once without rubbing too much of it away from the etched design. To make the color easier to wipe out, Frankfurter black and tallow may be mixed in it. Then the rag that has been used for inking-in is dipped into a mixture of twenty parts water, two parts gum, and one part aquafortis, or better still, phosphoric acid, and rubbed back and forth. The rag must not be too dirty and heavy with color, but it must contain some so that the delicate parts of the design shall not be wiped out and thus rendered susceptible to the acid. The next thing is to try with the finger to see whether the color on top can be easily rubbed away or not. In the latter case the wiping must be repeated till the cleansing mixture has so far prepared the surface that the wet hand or a wet piece of leather can cleanse it perfectly and free it from the dark tone. Now the stone is inked-in with firmer color (acid-proof ink is best). This is wiped off again thoroughly. Very weak aquafortis (or phosphoric acid if it has been used for the work) is then poured over it a few times, and this generally prepares it so well that it can be inked and cleaned easily during the printing. This method is useful for many kinds of art, and it must not be imagined that it is superfluous because the other ways are quicker.