The engraving-needle is very good for drawing the finer parts of the design through the etching-ground, but the coarser ones cause much trouble, while with the pen, these are the very ones that are easiest to produce. By using this method, both advantages can be combined and only that is drawn with the pen which is most readily produced that way. Thus the whole design, with the exception of the finest parts, is drawn on the white plate with the black preparing ink touche. Then, when it has been covered with acid-proof ink and made white, the finer parts are worked-in with the needle. Or they may be left till the end, when they are engraved-in. For grounding or blackening the plate, one may use a substitute for the acid-proof ink if the ground is to be firmer. Use the etching-ground (mentioned several times before) of wax, mastic, pitch, and resin, dissolved in oil of turpentine and mixed with fine lampblack. It will then be susceptible of being laid beautifully uniform on the stone with the ink-roller like printing-ink. The spattered aquatint method resembles this. The outlines of the design are engraved or etched into the stone very delicately. After rubbing-in with black printing-ink and cleaning again thoroughly, it is rinsed with a great deal of clean water to take away every trace of gum. When it is dry a small brush is dipped into the preparing-ink, and the stone is spattered as described in the article on spatter-work. After drying, the dots that are too large are treated with the needle, and missing ones are drawn in with the pen. Now apply the roller with the dissolved etching-ground, that must, however, have only enough color so that the outlines of the design can show through it. Then the spattered work is brought out by rolling with water. Now coat the lighter parts of the design and etch. Coat again and etch again, in short do as already described for the method of successive etching till the required gradations of shade have been attained. Then proceed as usual with the inking-in and printing. IV AQUATINT IN COPPER-PLATE STYLES AND WITH ETCHING-GROUND Any one who has the necessary appliances of the copper-plate worker for making the aquatint ground used by them, and who has the necessary skill, can do so, although the stone is endangered by the heat, and the process is not advisable. The stone is dusted with fine resin. A flame of spirits is applied below until the stone is so hot that the resin melts and forms the ground. Better is that copper-plate method in which the resin is dissolved in highly rectified spirits of wine and poured quickly over the whole stone. By breathing on this, the resin is made to separate from the spirits and form tiny pellets, which thus make the required aquatint ground.