Better even than this purified lampblack is one that one makes for himself from ox or other animal fat, from wax, or better still, from a mixture of ox fat and resin. The fat is melted and poured into an earthen lamp similar to those used for city lighting, with a cotton wick. The lamp is lit and placed under a plate of iron or brass, so that the smoke must settle on it. The plate must be close to the flame. The soot is scraped off from time to time and dropped into a glass, which is kept covered. This process continues, the lamp being refilled till one has the desired quantity. This soot is very fine and bland, and so good that one can do more with an ounce of it than with three ounces of the ordinary kind. The ink made from it is extraordinarily fine and good. It is to be noted in conclusion that the more soot is used, the blacker will be the ink, but the coarser will be the work, because the ink will have the tendency to spread. The less soot is used, the finer will be the work; but it is not easy then to see what one is doing or to judge if the design is strong enough. The quantities given in the formulas appear to me to be the best, especially if the self-manufactured soot is used. (3) To dissolve the ink, rain water or pure soft river water is best. The rain water must not be very old or stale, otherwise the solution will get slimy. (4) The severe combustion is not vital for making the ink, but helps very much in making it easy to use. (5) When shellac is part of the mixture, it is vital to burn the mass well, as only thus will shellac dissolve properly. Shellac, which is made in China and East India from an insect belonging to the bee family, will melt under moderate heat, but will not dissolve in any animal fat or oil unless it has previously lost its inherent acid, which occurs only under combustion. If shellac is melted with oil or fat, it covers the bottom of the vessel in the beginning. With heat increased till it causes combustion, it begins to swell, rises to the surface, and at last covers the surface in the form of a spongy mass. If the heat still increases, it begins to dissolve into foam. Then it is time to remove the mass from the fire and to cover it with a tight lid, that the flame may be extinguished. If shellac has been once melted and has hardened, it dissolves only slowly even under severe combustion. It is better, therefore, to bring the other substances to combustion first, and then to mix the shellac in small portions, which will dissolve much more readily because they will be attacked by the great heat in the moment of melting and will not have time to swell first and get hard. As soon as the mass has cooled a little, the second part of soap is added, and the whole heated, without burning, merely enough to melt the soap.