[Illustration: Fig. 16] IV THE WATTMETER We were able to maintain connections between the binding posts of the ammeter and the movable armature of flexible wires because the armature never moves more than one third of a revolution, but we now wish to examine an instrument in which the armature must not only make a complete revolution but must continue to revolve in the same direction indefinitely. How are connections made so that an electric current may pass from the fixed binding posts to the wire of the moving coil? I will lift the cover off this instrument, which is called a wattmeter, and let you find the answer to that question. I sent through the instrument the current from a 32-candle-power lamp. According to the ammeter, which was also in circuit, the amount was one ampere. The armature of the wattmeter revolved slowly and it was not long before the boys reported that connections for the current were made by strips of metal sliding on metal plates. The ends of the armature wire were fastened one to one plate and the other to the other plate, and the metal strips brush along over the surfaces of the plates. (That is why they are called "brushes," I said.) And the brushes slide from one plate to the other each time the armature makes half a revolution. (That is, the brushes change the connection and thus change the poles of the armature at the proper instant so that they are always attracted to the poles of the field toward which they are moving.) This is called a commutator.