The experiment was looked upon with great interest, and admitted to be of a very remarkable character; and, considering that it was a first attempt, it was not by any means regarded as unsuccessful. As it was believed that such a machine, if properly proportioned, might be employed to drag cannon into the field independent of horse-power, the Minister of War authorized Cugnot to proceed with the construction of a new and improved machine, which was finished and ready for trial in the course of the following year. The new locomotive was composed of two parts, one being a carriage supported on two wheels, somewhat resembling a small brewer's cart, furnished with a seat for the driver, while the other contained the machinery, which was supported on a single driving-wheel 4 ft. 2 in. in diameter. The engine consisted of a round copper boiler with a furnace inside provided with two small chimneys, two single-acting 13-in. brass cylinders communicating with the boiler by a steam-pipe, and the arrangements for communicating the motion of the pistons to the driving-wheel, together with the steering-gear. [Illustration: CUGNOT'S ENGINE.] The two parts of the machine were united by a movable pin and a toothed sector fixed on the framing of the front or machine part of the carriage. When one of the pistons descended, the piston-rod drew with it a crank, the catch of which caused the driving-wheel to make a quarter of a revolution by means of the ratchet-wheel fixed on the axle of the driving-wheel. At the same time, a chain fixed to the crank on the same side also descended and moved a lever, the opposite end of which was thereby raised, restoring the second piston to its original position at the top of the cylinder by the interposition of a second chain and crank. The piston-rod of the descending piston, by means of a catch, set other levers in motion, the chain fixed to them turning a half-way cock so as to open the second cylinder to the steam and the first to the atmosphere. The second piston, then descending in turn, caused the driving-wheel to make another quarter revolution, restoring the first piston to its original position; and the process being repeated, the machine was thereby kept in motion. To enable it to run backward, the catch of the crank was arranged in such a manner that it could be made to act either above or below, and thereby reverse the action of the machinery on the driving-wheel. It will thus be observed that Cugnot's locomotive presented a simple and ingenious form of a high-pressure engine; and, though of rude construction, it was a highly-creditable piece of work, considering the time of its appearance and the circumstances under which it was constructed.