knife is employed, provided it has a keen edge and is dexterously used. [Illustration: FIG. 4. PREPARED SHOOT.] The material most commonly used in times past for tying in the bud is the inner bark of the linden or basswood tree, usually called bass, and always to be procured in the form of mats, or as prepared from our indigenous basswoods and kept on sale at the seed stores. Recently, however, another excellent tying material has come into use, known in the trade as raffia or roffia. It is the cuticle of the Jupati palms. One species (_Raphia tædigera_) is a native of the lower valley of the Amazon and Orinoco, and another (_R. Ruffia_) of Madagascar and adjacent islands. Raffia is somewhat softer and more pliable than the ordinary bass, although it does not hold its form quite as well; but it is so cheap, soft and strong, that it has become very popular, and is extensively used for budding and many other purposes. But if none of these tying materials are at hand, the inner bark of the persimmon, corn husks, cotton twine, woolen yarn, or even strips of old muslin and calico may be employed with equally as good results, although not as handy and convenient for such purposes. The amateur, with only a few stocks to bud, can readily improvise implements and materials for doing the work, even if they are not of the regulation type. In selecting buds, the young shoots of the present season's growth are preferred, and these should be taken from the most healthy and vigorous branches of bearing trees, if possible. The leaves should be immediately removed, not by breaking or pulling off with the hand, but by severing the leaf-stalks with a knife, as shown in Fig. 4. If the leaves have fallen from the twig, the buds may be too ripe, with some kinds of plants, but with the almond, and where only a few leaves near the base have dropped, all may be used with fair success. If there are any soft and immature buds on the upper part of the shoot, or any undeveloped ones at the base, they should be rejected. Success in budding depends very largely upon the condition of the stocks at the time the operation is performed. Unless the sap is flowing and in sufficient abundance to allow the bark to part or peel readily from the wood underneath, the bud is certain to fail. If the buds used should happen to be a little over-ripe or wholly dormant when placed in direct contact with the living tissues and the juices of the stock, they will absorb moisture and nutriment, and be as likely to unite and live as under opposite conditions. [Illustration: FIG. 5. INCISION FOR BUD.]