As a preliminary to this, a brief outline of the problem before the lens designer may be of interest. A simple lens consists of a piece of glass bounded by either plane or spherical surfaces as these, except in large reflecting surfaces, are the only kind that can be made with sufficient accuracy. Such a lens would have a great many defects or errors and would be unable to give a sharp image on the photographic plate unless stopped down to a very small aperture. By changing the radii of the surfaces, and the thickness of the lens, the designer can vary these errors, but after all is said and done he can do but little to improve the single lens. He then combines lenses of different forms and of different kinds of glass into a single objective, in this way making the positive errors of some of the lenses balance the negative errors of the others, until he arrives at a combination which is more or less perfect according to his skill as a designer. How this is accomplished is far beyond the limits of this paper, so I will now proceed to the mechanical side of the problem. The first consideration is the glass; of course it must be what is known as optical glass and its selection is really part of the work of the designer. Optical glass is nothing more than a very perfect kind of glass which has been exquisitely annealed. You are all familiar with the intense green of window glass when seen edgewise; a piece of white paper will hardly be changed in color when seen through twelve inches of a good optical crown. The best optical glass is not made in this country, but must be purchased from either Schott & Gen. of Jena or Mantois of France. The Jena glass has become very celebrated and most of the lens makers state that their lenses are made out of it and as a consequence most people think that Jena glass means a certain kind, while, as a matter of fact, their catalogue for 1909 shows about seventy different varieties. These differ in optical qualities and chemical composition, and cost from about a dollar to five dollars a pound, with a few special varieties costing as much as fifteen dollars. This glass comes in slabs, but will be cut by the makers with either a diamond saw or a sand saw, the purchaser paying for the “saw dust.” [Illustration: FIG. 1] [Illustration: FIG. 2]