The Preparation of Bees for Outdoor Wintering — John Shaqi
The Preparation of Bees for Outdoor WinteringPhillips, Everett Franklin
Science
The Preparation of Bees for Outdoor Wintering
Phillips, Everett Franklin
Bee culture
To prevent the tunnels from getting out of alignment at the outer
edge, a peg of the diameter of the holes is inserted through the
outer hole for each hive and into the tunnel (see fig. 2). This peg
is usually about 2-1/2 inches long. This leaves four auger holes,
each three-eighths of an inch in diameter, for the bees to use as an
entrance during the fall and spring, and during the colder weather a
piece of section material or a small board is tacked over three of
the holes. (See fig. 3.) This gives in winter a single hole for an
entrance, three-eighths of an inch in diameter. This provides a place
for the bees to remove their dead, a place for flight on moderately
warm days, and also provides adequate ventilation for the hive while
the bees are confined without an opportunity for flight. However, the
size of entrance should not be discussed without warning beekeepers
that unless adequate packing is provided, such a small entrance may
result in the death of the colony. Furthermore, a poorly packed
colony will not be able to carry out the bees as they die, and the
death rate will be higher; and these things combined may result in
an accumulation of dead bees at the entrance, which will serve to
suffocate the remaining bees. A colony that is well packed, however, is
able to remove all dead bees as fast as they die, and there will never
be an accumulation on the floor of the hive. Furthermore, a well-packed
colony does not need so large an entrance for ventilation as does one
that is not packed or which has not enough packing. If snow drifts over
the small entrance here described, the beekeeper need have no anxiety,
for the bees can still receive adequate ventilation. If a crust of
ice closes the entrance it will be well to break it, but usually the
escaping heat will melt this ice before any damage is done.
[Illustration: Fig. 5.--Map of the eastern United States indicating
average date of first killing frost in autumn. On this the zones for
winter packing are based. No packing is recommended in zones A and B.]
WINTER SCHEDULE.
Great confusion has existed among beekeepers as to the right time
to pack the bees for winter, and especially as to the right time to
remove the packing in the spring. It is quite possible to give definite
directions for both procedures and to place the recommendations on a
firm foundation by basing them on weather phenomena. The maps (figs.
5 and 6), showing the time of the first average killing frost in the
fall, serve as a basis for the recommendations for each of the zones
into which the map of the eastern United States is divided. Perhaps it
will be a matter of surprise to beekeepers in parts of the South to see
that, so far as the wintering of the bees is concerned, they are as far
north as beekeepers who live many miles farther toward the pole.
Public-domain text, read in full here on John Shaqi.
Reviews
Reviews
No reviews yet
Be the first to share your thoughts on this work.
Join the Discussion
Join the discussion
Sign in to leave a comment or review.
Sign InorCreate an account