Once the printer or his apprentices had set the type, pulled a proof, “made up” the type into pages with the proper spacing and ornaments, and then locked it into forms by means of furniture and quoins, he placed his form on the press and adjusted it to get the most even impression. Then he was ready to begin the actual process of printing. Whereas printing is commonly done today by automatic presses, fed with paper either mechanically or by hand, it had to be done one sheet at a time in the eighteenth century. Two men usually worked the press, and the printing of a single impression required approximately a dozen different manual operations. To ink his press, preparatory to printing, the “beater” spread the necessary amount of ink on his mixing block and rubbed it to an even consistency—that of stiff molasses—with a wooden brayer. With two leather-covered balls attached to wooden handles, he then collected ink from the stone, beat the “ink balls” together to distribute the sticky fluid over their surfaces, and then with a rapid rocking and rolling motion, transferred it onto the type. Then the “puller” placed his paper on a skin-covered wooden frame called a tympan and folded over it another light covered frame, called a frisket. These two frames in turn folded down onto the bed of the press, where the type was locked in its iron form or chase. The actual impression was made by rolling the bed of the press, complete with folded tympan and frisket, beneath the platen, which was suspended from a large metal screw. By applying the force of the screw, the puller pressed the paper firmly against the inked type. The size of the printed matter might vary from a small bookplate or lottery ticket to a sheet twelve by eighteen inches, which was roughly the page size of Purdie and Dixon’s _Virginia Gazette_ of 1759. Whatever the dimension, the beater had to ink his form and the puller had to close and open his press again each time a surface was printed. Since the platen was so small, only one-half of a two-page wide newspaper could be printed at a time on the early press, and a repeat operation was required to complete one side of the sheet. Thus the press was sometimes called a “two-pull” press. Two experienced pressmen, working at full speed, could turn out a “token” or 240 printed sheets (with two pulls and on one side only) per hour. Such a speed could not long be maintained; the practical output was closer to 200 sheets per hour. But wages were low, working hours were long, and the printer could keep his force on the job until the work was done. _THE PRINTER AND HIS MEN_