Getting ready for port. Coming to anchor,--close-hauled--free. Mooring. Flying moor. Clearing hawse. To anchor with a slip-rope. Slipping a cable. Coming-to at a slipped cable. GETTING READY FOR PORT.--Get your anchors off the bows, and let them hang by the cat-stoppers and shank-painters. Bend your cables and overhaul a few ranges forward of the windlass, according to the depth of the anchorage and the strength of the tide or wind, and range the remainder that you expect to use along the decks, abaft the windlass. Have the boats ready for lowering, and a spare hawser, with some stout rope for kedging or warping, at hand, coiled on the hatches. COMING TO ANCHOR.--If you have the wind free and all sail set, take in your studdingsails, make them up and stow them away, rig in the booms and coil away the gear, and have all ready in good season. You may then, as you draw in toward the anchorage, take in your royals and flying jib, furling the royals if you have time. The topgallant sails are next taken in, and the foresail hauled up. The topgallant sails may be furled or not, according to the strength of the wind and the number of hands. If you are before the wind, your mainsail will be hauled up, or, if the sheet is aft, haul up the lee clew-garnet. Get your ship under her topsails, jib and spanker. When near the ground, clew up the fore and main topsails, put the helm down, haul down the jib and flatten in the spanker. If you have too much headway, back the mizzen topsail. Cock-bill your anchor and stream the buoy. When she has lost her headway, let go the anchor. Let hands stand by to give her chain, as she needs it. If you come into anchoring ground close-hauled, haul in the weather fore and main braces, and clew up. If the wind is light, you may square the fore and main yards before clewing up. This will deaden her way. If the wind is fresh, it would make it difficult to clew up the sails. Haul down the jib, and come to by the spanker, or mizzen topsail and spanker. If the wind is light, she may need the mizzen topsail; if not, it may be taken in, and she may be brought to by the spanker. If she has too much headway or there is a tide setting her in, throw all aback. MOORING.--A vessel is said to be moored when she rides with more than one anchor, in different directions. The common method of mooring is, when you have come to with one anchor, to pay out chain and let her drop astern until you have out double the scope you intend to ride by. Then let go your other anchor. Slack up the cable of the latter anchor, and heave in on that of the first, until you have the same scope to each anchor. You may also moor by lowering the anchor and lashing it to the stern of the long boat, and coiling away the full scope in the bottom of the boat. You may then pull off and pick out your own berth, and let go.